3onedata TNS5800D Series Snelle installatiehandleiding - Pagina 2
Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} 3onedata TNS5800D Series. 3onedata TNS5800D Series 4 pagina's. Layer 3 wall mounting industrial ethernet switch
Ook voor 3onedata TNS5800D Series: Snelle installatiehandleiding (4 pagina's), Snelle installatiehandleiding (4 pagina's)
Pagina afdrukken
3.
Running indicator (RUN)
4.
Relay alarm output interface
5.
Grounding screw
6.
CONSOLE port
7.
Lugs
8.
Power input interface (P1-P2)
9.
Gigabit Bypass M12 interface (Bypass: G1-G2, G3-G4)
10. PoE indicator (E1-E16)
11. 100M PoE M12 interface (E1-E16)
12. Ethernet port indicator (E1-E16, G1-G4)
13. Gigabit Bypass M12 interface (Bypass: G17-G18,
G19-G20)
14. PoE indicator (G1-G16)
15. Gigabit PoE M12 interface (G1-G16)
16. Ethernet port indicator (G1-G20)
【Mounting Dimension】
Unit: mm
Model I and Model II
Model III and Model IV
Notice Before Mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【Wall-mounted Device Mounting】
Model I and Model II
Step 1
On the wall of device mounting, place the device on
the wall for reference or refer to the mounting
dimension to mark two screw positions.
Step 2
Hang the device on the labeled wall, align the bolt to
the labeled position, then fix them with a certain gap.
Step 3
Slide the device down to hang on the screw, then
tighten the screw, and the installation is finished.
Model III and Model IV
Step 1
On the wall of device mounting, place the device on
the wall for reference or refer to the mounting
dimension to mark two screw positions.
Step 2
Nail screws on the wall and keep 7mm interspace
reserved.
Step 3
Hang the device on 4 screws and slide downward,
then tighten the screw. Mounting ends.
【Wall-mounted Device Disassembling】
Model I and Model II
Step 1
Power off the device.
Step 2
Hold the device steady and unscrew the screw on
the wall.
Step 3
Take out the device, disassembling ends.
Model III and Model IV
Step 1
Power off the device.
Step 2
Unscrew the screw on the wall about 7mm.
Step 3
Lift the device upward slightly; take out the device,
disassembling ends.