DAMPP-CHASER Piano Life Saver System Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} DAMPP-CHASER Piano Life Saver System. DAMPP-CHASER Piano Life Saver System 9 pagina's. Backside vertical 8-part system which includes two humidifiers
Ook voor DAMPP-CHASER Piano Life Saver System: Installatie-instructies (4 pagina's), Handleiding voor installatie-instructies (8 pagina's), Instructies voor verzorging en onderhoud (2 pagina's)

Pagina afdrukken

DAMPP-CHASER Piano Life Saver System Handleiding voor installatie-instructies

STEP 1. HUMIDIFIER INSTALLATION

You should install the Humidifier first. When you unpack the

System box, you will find several items in the Humidifier tank:

Humidifier pads, the two-light panel, and the watering tube.

Remove the light panel and pads for later use. Uncoil the

watering tube and leave it outside the tank. Make sure the end of

the tube is within the plastic liner inside the tank. Please note the

Water Sensor probes and Humidifier heater bar are attached to

the Humidifier at the factory. The Water Sensor probes are

attached to the Humidifier heater bar mounting bracket at the

middle of the Humidifier (Figure 1).

The Humidifier pads are designed to wick water over the heater

bar, producing warm moist air currents which rise and are cir-

culated throughout the piano. The Smart Bracket sensors

(Figure 2) will signal via a red light when the pads no longer

wick water and require replacement. The Smart Bracket also

turns off the Humidifier heater bar when the pads fail or when the

Humidifier runs out of water.

FIGURE 1

Humidifier with

pads installed

Humidifier placement

Water sensor

probes

attached

to middle

mounting

brackets

FIGURE 3

Mounting the Smart Bracket: You will mount the Smart

Bracket outside the Clean Sleeve

(Figure 2). The Sleeve protects the Heater Bar from corrosion

caused by excessive minerals in the water.

Open the SB package and take out the SB sensors (with

attached C clips) and the red SB single-light cube. Put aside the

light for later. To attach the sensors to the heater bar, slide the

C clips on the SB sensors into the positions shown in Figure 2

and press firmly downward. The sensors on the Smart Bracket

should lie on the top of the heater bar.

Drape the Humidifier pads across the heater bar and push them

down into the tank as shown in Figure 1. If necessary, adjust

the C clips on the SB sensors to insure the pads are in direct

contact with the sensors. Unbundle the cords from the SB, the

Water Sensor probes and the Humidifier heater bar.

Remove the bottom panel of the piano and put the Humidifier

tank on the floor in the bottom corner of the treble or bass end

(Figure 3). Place the tank in the side where the trapwork does

not interfere.

P P P P P AD

Smart Bracket

Heater

Bar

FIGURE 2

NOTE: If the Smart Bracket is not mounted

OUTSIDE the Sleeve, the red "Pads" light

(on the light panel) will blink constantly.

on the Humidifier Heater Bar

Always mount the

Smart Bracket

probes outside the

plastic Sleeve.

P P P P P AD