AIRTUG EL3-s Montage- en bedieningsinstructies - Pagina 4

Blader online of download pdf Montage- en bedieningsinstructies voor {categorie_naam} AIRTUG EL3-s. AIRTUG EL3-s 5 pagina's.

Airtug® / 1350 Chester Industrial Parkway, Avon OH 44011 / 216-941-9781 / www.airtug.com

Step 4: Route the large transaxle control cable up the handle

and connect the cable section with two (2) nuts to the the

bracket on the left side of the tug handle. Separate the nuts

equal distance to ﬁt in place on the bracket and tighten the

nuts securely in place. Install the quick-connect ﬁtting at the

top of the cable to the ball on the left side of the twist grip

handle. It is spring loaded and will hold securely in place.

Using the zip ties provided, secure the cable to the handle.

Step 5: Lead the wires from the end of the tug handle through

the hole on the right side of the tug frame just behind the

solenoid and install the rubber grommet in the hole of the tug

frame. Take care not to damage the wires or the grommet when

inserting the grommet into the hole in the tug frame. Use a tool

with a very dull edge to help seat the grommet. It takes a little

patients to install this part. Connect the red wire ring terminal to

the solenoid terminal marked with red tape and connect the

other wire (green) ring terminal to the solenoid terminal marked

with green tape. Tighten the nuts securely.

Step 6: Prior to the ﬁrst use, plug the charger cable into a 110V

outlet or extension cord and charge the batteries fully as

indicated by the green light at the top of the charger. The

orange light indicates batteries are charging. Keep the battery

charger plugged in between use. See the battery charger

manual for more information.

Final Step: Install the protective battery and motor cover and

secure to the tug frame using the (4) 5/16 bolts, washers and

nuts.