Dan D'Agostino classic stereo Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dan D'Agostino classic stereo. Dan D'Agostino classic stereo 14 pagina's.

Package contents

If any of the following items are missing, please contact your dealer:

1 Classic Stereo amplifier encased in protective vinyl

2 XLR-to-RCA adapters

Unpacking the Classic Stereo amplifier

The Classic Stereo amplifier weighs more than 100 pounds, so it's too heavy for one

person to lift safely. To unpack the amp, first move the box near to a location near where it

will be installed. Remove anything from your person that might scratch the amplifier's

finish, such as watches, rings and belts with metal buckles. Two people should lift the

amplifier onto a soft surface, such as a towel or blanket. Lay the amp on its back, carefully

remove the plastic wrap, then turn the amplifier upright and sit it on its feet. You can now

place the amplifier on the stand or rack you'll be using.

Because this amplifier weighs 108 pounds, please make sure the surface that will support

the amplifier can safely hold its weight. Adequate ventilation must be provided for the

amplifier. There should be at least 3 inches of clearance on each side and 3 inches of

clearance at the top. The bottom vents must not be obstructed by thick carpet, dust, etc.

We recommend that the amp be installed in an open equipment rack to assure proper

ventilation. The amp may be installed in a closed cabinet or in an equipment closet, but

the cabinet or closet must be designed with substantial ventilation at top and bottom;

active ventilation (i.e., powered fans) is preferred. Do not place the amplifier directly on a

carpeted floor (we recommend using a rack or an amplifier stand if the floor is carpeted),

and make sure that dust is not allowed to accumulate around the amplifier.

Do not plug the Classic Stereo amplifier or any other Dan D'Agostino Master Audio

Systems product into a power strip or power conditioner.

Rack-mounting the Classic Stereo amplifier

The rack-mounting holes in the Classic Stereo amplifier's front panel have screws installed

at the factory. These make the amp look nicer when it's not rack-mounted. If you will be

rack-mounting your Classic Stereo, be sure to remove these screws first.

If you need to return the amplifier for service

If you should need to send the Classic Stereo amplifier back to us for service, be sure to

use the original box and materials for shipment.

Before you ship the amplifier, unplug it from the wall and let it cool down for 6 hours. To

protect the finish during shipping, rewrap the amplifier in the vinyl covering it came in.

Make sure the amp is completely cool and has not been plugged in for 6 hours before you

do this. Wrapping the amplifier when it is warm will cause the vinyl to leech into the

amplifier's surface and will permanently damage the finish.

1 owner's manual

1 AC power cord