Dan D'Agostino Momentum Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dan D'Agostino Momentum. Dan D'Agostino Momentum 15 pagina's. Hd preamplifier
Ook voor Dan D'Agostino Momentum: Gebruikershandleiding (13 pagina's), Gebruikershandleiding (13 pagina's), Gebruikershandleiding (10 pagina's), Gebruikershandleiding (11 pagina's), Gebruikershandleiding (11 pagina's)

Swap the left-channel interconnect cable from the source device to the preamp

with the right-channel interconnect cable. if the malfunctioning channel now works

but the other channel does not, replace the defective interconnect cable with one

of the exact same type. You may have to replace both left and right cables to make

sure they match.

Try using a different source device. if the alternate source device delivers sound

in both channels, it is likely the original source device is defective. Consult the

manufacturer of that source device or your dealer for further information.

if possible, try using a different amplifier. if the alternate amplifier delivers sound in

both channels, it is likely the original amplifier is defective. Consult the manufacturer

of the amplifier or your dealer for further information.

if all of these steps fail to restore sound, consult your dealer for service.

Preamp functions but remote control does not

Follow these steps in order. if one step succeeds in restoring the operation of the remote, stop

there and ignore the other steps.

Try pointing the remote directly at the preamp (or at the iR receiver if you're using

an iR repeater system).

Check the iR emitter on the front of the remote to make sure it is not dirty. if it is,

wipe off any dust and/or fingerprints with a soft cloth.

if you are using the iR module, make sure that the .25 in / 6 mm round port on the unit

is facing you as you use the remote.

if you are using the iR module, make sure it is plugged in and activated. Unplug it from

the remote control input on back and reinsert the plug, making sure it is firmly seated.

now turn the power to the preamp's power supply off, then turn it back on again. The

iR module should now be activated.

if you are not using the iR module, make sure it is unplugged and deactivated. Check

the back panel to make sure nothing is plugged into the remote control input. now turn

the power to the preamp's power supply off, then turn it back on again. The preamp's

integral front-panel iR sensor should now be activated.

Change the batteries by removing the screws securing the back plate of the remote,

replacing the batteries with fresh ones, then replace the back plate.

if all of these steps fail to restore operation of the remote, consult your dealer.