Concept Perugini YT 165 Instructieboek - Pagina 8

Blader online of download pdf Instructieboek voor {categorie_naam} Concept Perugini YT 165. Concept Perugini YT 165 15 pagina's. Flail mowers

ALWAYS MAKE SURE THE TRACTOR IS TURNED OFF, P.T.O

IS DISENGAGED AND MACHINE IS MADE SAFE

Attaching the machine to the Tractor

Concept Perugini Flail toppers can be linked up to any tractor with a category 1

three point linkage.

Read the tractor's instruction manual before attaching attempting to attach the

machine to the tractor.

•

Adjust the width of the tractor arms to match the lower brackets on the

machine

•

On a flat surface reverse the tractor up to the machine

•

Firstly attach the lower links and do the necessary adjustments to limit

sideways movement

•

Lengthen and attach the top link in order to have the machine parallel to the

ground once attached

•

Remember to fit all the locking pins and that the machine is safely secured

to the tractor

If necessary, cut the PTO shaft to the right length following the shaft

manufacturer instructions.

When attaching the PTO shaft to the machine and tractor make certain that if the

PTO shaft is fitted with an overrun clutch this must be installed on the implement.

When connecting to the tractor verify that the locking pin is correctly located and

secure in place. Before use make sure all the chains and guards are correctly

fitted.

The height of the machine from the ground is controlled by the rear roller, skids

and top link. Before using the flail mower make sure that the flails do not hit the

ground, this will result in extreme wear will damage the rotor.

Always adjust the top link to keep the machine parallel to the ground when

adjusting the height of the rear roller.

The working depth is set by altering the

position of the rear roller support.

To do this:

Slacken bolt A

•

Remove and reposition the support in B

•

Tighten all bolts

•

Repeat for both sides