3onedata IAP2600A-BW-8A25-2GT-PDP12 48 Snelle installatiehandleiding - Pagina 2

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} 3onedata IAP2600A-BW-8A25-2GT-PDP12 48. 3onedata IAP2600A-BW-8A25-2GT-PDP12 48 5 pagina's. Industrial outdoor 5g wireless router

Pagina afdrukken

Wall Mounting or Pole Mounting location hole

5.8G antenna interface

5G Sub-6G antenna interface

2.4G antenna interface

10/100/1000Base-T(X) LAN port

Terminal block for power input

Grounding screw

10/100/1000Base-T(X) PoE WAN port (PoE input)

SIM card slot (SIM1, SIM2)

10.

Reset button

11.

Running indicator (RUN)

12.

WLAN indicator (WLAN)

13.

5G Indicator (5G)

14.

Gigabit WAN indicator (WAN)

15.

Gigabit LAN indicator (LAN)

16.

5G signal strength indicator（

17.

Breather valve

【Mounting Dimension】

Unit: mm

Notice Before Mounting:

Don't place or install the device in area near water or



moist, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before power on, first confirm the supported power



supply specification to avoid over-voltage damaging the

device.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【Pole-mounted Device Mounting】

Step 1

Use 4 M6 screws to install the clamp board as

shown in the figure below on the device backboard.

）

Step 2

Align the other clamp board with the hole center

line of the installed clamp board, then place the

support pipe to align the hole center of the two

clamp boards. When the two clamps are docking, it

can choose 15° or 90° installation angle.

Step 3

Pass the M6 long screw through the hole where the

clamp boards are docked and the support pipe, and

tighten the corresponding M6 nut.

Step 4

Install U-shaped derrick screws and derrick teeth

on the clamp board, and put the derrick with a

diameter of 40 mm - Ф Ф 50 mm in an U-shaped

slot, as shown in the figure below.

Step 5

Adjust device position and tighten the derrick nut to

fix the position of the device on the derrick.

Installation ends.