ducduc OSLO Montagehandleiding - Pagina 4

Blader online of download pdf Montagehandleiding voor {categorie_naam} ducduc OSLO. ducduc OSLO 11 pagina's.
Ook voor ducduc OSLO: Montage-instructies (4 pagina's)

Pagina afdrukken
3
Attach one LOCKING WASHER
BOLT
and insert each RAIL CONNECTOR BOLTS
tighten with ALLEN WRENCH
4
Align second END RAIL
bottom and inside of CRIB. Refer to diagram for proper orientation. Attach one LOCKING WASHER
and one REGULAR WASHER
CONNECTOR BOLTS
Do not tighten all the way.
and one REGULAR WASHER
. Do not tighten all the way.
K.2
L.2
to SIDE RAIL
to two RAIL CONNECTOR BOLT
in rail connector holes and slightly tighten with ALLEN WRENCH
B
A
in rail connector holes and slightly
L.2
F
making sure that mattress support holes face the
5
5
5
5
5
5
tipping over during assembly step 6.
One person holds onto crib to prevent it from tip
tipping over during assembly step 6.
tipping over during assembly step 6.
tipping over during assembly step 6.
tipping over during assembly step 6.
assembly step 6.
to two RAIL CONNECTOR
6
Line up other SIDE RAIL
G
6
align with the rail-connector-holes on the END PANELS
6
6
6
6
6
Line up remaining SIDE RAIL
Line up remaining SIDE RAIL
Line up remaining SIDE RAIL
Line up remaining SIDE RAIL
Line up remaining SIDE RAIL
Line up remaining SIDE RAIL
Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
END RAILS . Attach LOCKING WASHERS
to RAIL CONNECTOR BOLTS
BOLTS
and insert and slightly tighten the fo
and insert and slightly tighten th
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
and insert and slightly tighten the
and insert and slightly tighten the
and insert and slightly tighten th
and insert and slightly tighten th
the four RAIL CONNECTOR BOLTS
WRENCH
as in steps 3 and 4. Do not tighte
WRENCH
as in steps 3 and 4. Do not tig
WRENCH
WRENCH
WRENCH
WRENCH
as in steps 3 and 4. Do not tigh
as in steps 3 and 4. Do not tigh
as in steps 3 and 4. Do not tig
as in steps 3 and 4. Do not tig
ALLEN WRENCH
G
and insert each RAIL
K.2
L.2
F
K.2
L.2
G
2
2
2
2
2
2
1
1
1
1
1
1
1
so its rail-connector-holes
A
so its rail conne
so its rail-co
so its rail con
so its rail con
so its rail con
so its rail co
K.2
and REGULAR WASHER
F
and insert and tighten
with
F
as in steps 3 and 4.
.