Anyload EC200 Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Anyload EC200. Anyload EC200 8 pagina's.
Ook voor Anyload EC200: Bedieningshandleiding (16 pagina's)
Pagina afdrukken
Press <Enter> to set zero point. (UNIT WEIGHT display will show CAL-0 flashing
for a few seconds and then changes to XXXX to set the Calibration weight).
Press <CE> button and then press <NUMERIC (0-9) KEY> to set the calibration
weight. Calibration weight will show on the UNIT WEIGHT display. Put the test
weight on the bigger platform. Press <ENTER> button, the UNIT WEIGHT display
will show a flashing XX then change to XX.XXX lb. Then the Calibration procedure
complete.
7.1.3 Check Calibration:
Reboot the
scale.
not. If not, please redo the above Calibration procedure.
7.2 Scale 2 Calibration:
Turn on the scale, then press <1>, <3>, <1>, <2>, <Enter> when the scale
examining itself.
7.2.1 Menu setting:
'WEIGHT display' shows SCALE2,
'UNIT WEIGHT display' shows CAL-0.
'TOTAL display' will show A/D value.
Then press <UNIT> button to select calibration units between kg and lb.
7.2.2 Calibration:
Make sure nothing loaded on the smaller platform.
Press <Enter> to set zero point. (UNIT WEIGHT display will show CAL-0 flashing
for a few seconds and then changes to XXXX to set the Calibration weight).
Press <CE> button and then press <NUMERIC (0-9) KEY> to set the calibration
weight. Calibration weight will show on the UNIT WEIGHT display. Put the test
weight on the smaller platform. Press <ENTER> button, the UNIT WEIGHT display
will show a flashing XX then change to XX.XXX lb. Then the Calibration procedure
complete.
7.2.3 Check Calibration:
Reboot the scale. Place test weight on the scale and see the weight is correct or
not. If not, please redo the above Calibration procedure.
Page 7 of 8
Place test weight on the scale and see the weight is correct or
AL-Manual-EC200-En-101