Anyload S2 Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Anyload S2. Anyload S2 15 pagina's.

again, please turn it off, then turn it on again.

5.2 Installation of the indicator

Install the antenna on the indicator, Press ON key, (if no display, check the

button on the indicator left side to check if it is turn on) after several seconds,

the

signal will be shown on the screen, it means communication is normal.

After the operation, turn off the scale first, then turn off the indicator.

The indicator will turn off after 30minutes if no signal or without operation

automatically.

5.3 Recharge battery

5.3.1 Low battery

When indicator displays

, it means the battery needs to be recharged

soon, and the indicator will turn off automatically after one minute to save the

battery.

In weighing mode, if it displays "Low battery", it means that scale body

batteries are low, you need to recharge, otherwise it will turn off automatically

30 minutes later.

5.3.2 Charger

The indicator charger NC1056 has 3 statuses: when it's connected to 220V

power, the light is green; when recharging, it becomes red; if recharging is

finished, it becomes green.

Note: Generally recharging of the indicator needs 5-7 hours, if finished, the

current will become small to protect battery, you'd better to plug out to protect

the battery

5.3.3 Recharge the batteries of the scale body.

The scale body powers by 4 RCR123A batteries, when the indicator shows

"AD battery low", the scale body will be shut down automatically. To recharge

the batteries, unscrew the battery cap and pull out the batteries carefully, push

the flat batteries into the 16340 digital battery charger, connect the charger to

100~240VAC, if the LED light of the charger becomes red, the batteries is in

the process of charging.

When the LED light of the charger becomes green, the recharging is finished,

put the batteries back in the battery cap. Please notice the place of anode and

cathode when pit in the batteries. All the cathode of RCR123A battery is

Page 14 of 15 AL‐Manual‐110ES‐WL‐S2‐En‐103