Duco iAV Snelstarthandleiding - Pagina 11

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Duco iAV. Duco iAV 16 pagina's. Casing
Ook voor Duco iAV: Snel aan de slag (2 pagina's)

Pagina afdrukken

06 Calibration

For the system to work correctly, it needs to be configured� This helps ensure the quietest possible and most energy-efficient oper-

ation� See under the Tools heading at www�duco�eu for information about determining ventilation flow rates�

The adjustment procedure depends on whether iAV is operated as master (stand alone) or as slave (external control)�

06.A Calibration with iAV as slave (EXTERNAL CONTROL)

Follow the adjustment procedure described in the manual of the master unit�

06.B Calibration with iAV as master (STAND ALONE)

Follow the steps described in this chapter to install components� The adjustment is done in two phases: setting exhaust vents and

actual adjustment�

Setting exhaust vents

The exhaust vents are installed in an exhaust duct for moisture-laden/stale air extraction� In order to calibrate the air extraction

correctly, these vents must be set depending on the situation in accordance with the table below� The possible situations can be

found on the following page� When using DucoVent Design exhaust vents always leave the outer ring in place for an acoustic effect�

DUCOVENT

FLOW RATE

DESIGN

75m3/h

50m3/h

25m3/h

Acoustic

ring

Situation 1: one vent per iAV Control Valve

Set all vents to the fully open position, regardless of the desired flow rate� When using DucoVent Design exhaust vents, leave the

outer ring in place for an acoustic effect�

DUCOVENT BASIC

AND OTHER VENTS

100% open

50% open

25% open

L1020502 Quick start iAV control valve (Revision F | 25.10.2022)

ENGLISH