DUCTMATE REPEATER 4200 Bedienings- en onderhoudshandleiding - Pagina 8

Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} DUCTMATE REPEATER 4200. DUCTMATE REPEATER 4200 12 pagina's.

Pagina afdrukken
O P E R A T I N G T H E T O O L C o n t .
Operation in Cold Weather
When operating tools at temperatures near and below freezing, the moisture in the air line may freeze and prevent
tool operation:
1.
Reduce the air pressure to 80 psi (5.5 bar) or less.
2.
Removed all fasteners from magazine.
3.
Connect air and free-fire (blank-fire) the tool. Slow speed operation tends to worm up the moving part.
CAUTION: Do not store tool in a cold weather environment to prevent frost or ice formation on the tools
operating valves and mechanisms that could cause tool failure.
Operation in Hot Weather
Keep tool out of direct sunlight as excessive heat can deteriorate bumpers, o-rings and other rubber parts resulting in
increased maintenance.
T R O U B L E S H O O T I N G G U I D E
WARNING: Disconnect air from tool before all repairs!
Stop using the tool immediately if any of the following problems occur. Serious personal injury could occur. Any repairs
or replacements must be done by a qualified person or an authorized service center only.
PROBLEM
Trigger valve leaks air
Frame and nose leaks air
Frame and cap leaks air
Skipping fasteners
Intermittent feed
Lack of power
Sluggish
Fasteners jam in tool
8.
CAUSE
O-rings in trigger valve housing are damaged
Loose now screw
Damaged o-rings or gasket
Bumper cracked/worn
Loose cap screws
Damaged seal or gasket
Worn bumper
Dirt in nose
Dirty/dry magazine
Damaged magazine
Air restriction/inadequate air flow
Worn o-ring on piston or lack or lubrication
Trigger valve o-ring cut/worn
Leaking cap gasket
Worn/damaged pusher spring
Broken and damaged driver blade
Fasteners too short or wrong size for tool
Bent fasteners
Air leaks
Low air pressure
Lack of lubrication
Damaged or worn o-ring/sea
Exhaust blocked
Driver channel worn
Wrong size fasteners
Bent fasteners
Broken and damaged driver blade
Loose magazine, nose screw
CORRECTIVE ACTION
Replace o-ring
Tighten screws and recheck
Replace o-ring or gasket
Replace bumper
Tighten screws and recheck
Replace seal or gasket
Replace bumper
Clean
Clean/lubricate use pneumatic tool oil
Replace magazine
Fitting hose or air compressor needs to be checked
Replace o-ring. Lubricate.
Replace o-ring
Tighten screw, replace gasket
Replace spring
Replace driver blade
Use recommended fasteners only
Discontinue using these fasteners
Tighten screws and fittings
Check air supply
Use pneumatic tool lubricant
Replace o-ring/seal
Check bumper, head valve spring
Replace nose/check door
Use recommended fasteners only
Discontinue using these fasteners
Replace driver blade
Tighten all screws