Dudley Vantage Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} Dudley Vantage. Dudley Vantage 2 pagina's. Concealed wc cistern

Pagina afdrukken

TROUBLESHOOTER

Symptom

Possible Cause

No water flow from inlet valve.

Mains supply tap not open.

Isolating valve not open

Filter blocked

Float arm not free to move

Float stuck on/in float chamber

Inlet valve not shutting off.

Seal missing on float lever arm

Filter and 'O' ring missing

Valve has become dislodged from mounting

bracket

Float chamber/float set too high

Float lever arm dislodged from mounting

Front nut loose

Blue restrictor not fitted at very high mains pressure

Monitoring pin seized

Low flow from inlet valve.

Blue restrictor fitted when water supply is tank fed

Filter blocked

Turbulent and noisy flow from

Blue restrictor not fitted when water supply is

inlet valve.

mains fed

Lay flat tube missing

Lay flat tube not hanging vertically

Internally overflowing.

Inlet valve not shutting off

Water level set too high

Outlet valve not closing. (Water

Bellows not evacuating all air

continually running into pan).

Build up of debris on seal face of housing or seal

Outlet valve closing before full

Seal not clearing window

volume delivered.

Lack of air to inflate bellows

Push button leaking

Bellows poorly fitted to lever mount

Outlet valve not operating with

Pneumatic pipes not connected

push button.

Bellows poorly fitted to lever mount

Bellows leaking

Push button leaking

Leaking from flush pipe

Damaged 'O' rings on cistern outlet

connection.

Flush pipe seam protruding

Flush pipe cut at angle

Flush pipe cracked

Partial flush volume when

Wrong position of pneumatic pipes

operating full flush button.

Full flush volume when operating

Adjustable weight not retained on locating studs

partial flush button.

Wrong position of pneumatic pipes

Button sticking on Vantage with

Collet not located correctly

Niagara valve.

0121 530 7000

0121 557 5345

[email protected]

www.dudleybathroomproducts.co.uk

Thomas Dudley Ltd, P.O.Box 28, Birmingham New Road, Dudley, West Midlands, DY1 4SN

Remedy

Open supply tap.

Open isolating valve.

Remove filter and clean.

Mount valve correctly, straighten bent float stem.

Adjust float/float chamber height (ensure float

remains inside float chamber at all times).

Replace seal in arm.

Replace filter and 'O' ring.

Re-engage valve in bracket.

Adjust float chamber/float position.

Re-fit or replace lever arm.

Tighten nut.

Fit blue restrictor.

Replace diaphragm assembly.

Remove blue restrictor.

Clean filter.

Fit blue restrictor.

Replace lay flat tube.

Re-fit lay flat tube.

See 'B' above.

Lower float on inlet valve.

Relieve by removing pipe to valve.

Clean surfaces.

Check for leaks on bellows and push button.

Check push button for leaks.

Replace push button.

Push-fit bellows into lever mount.

Re-connect pipes.

Push-fit bellows into lever mount.

Replace bellows.

Replace push button.

Replace 'O' rings.

Trim seam with knife.

Replace flush pipe and cut square.

Replace flush pipe.

Substitute pipes.

Re-connect weight.

Substitute pipes.

Ensure collet is fully engaged.

SISLF323990

11644 iss D

Vantage

Concealed WC Cistern

Installation Instructions

PACK CONTENTS

2 x Partition

(Not supplied with 6L Mono)

Vantage cistern

Push button

Complete with flush valve, inlet valve,

isolating valve and flow restrictor.

(Style may vary)

Push-fit elbow

Pan Connector

750mm Green tube

750mm Clear tube

(Dual Flush Only)

2 x Mounting bracket

Push-fit flushpipe