Anywire ASLINKAMP LB-F1011 Producthandleiding - Pagina 6
Blader online of download pdf Producthandleiding voor {categorie_naam} Anywire ASLINKAMP LB-F1011. Anywire ASLINKAMP LB-F1011 11 pagina's. Fiber amplifier
Ook voor Anywire ASLINKAMP LB-F1011: Producthandleiding (11 pagina's)
Pagina afdrukken[Transmission line connection]
Connect the transmission line of the base unit to the transmission line
from the master unit.
This terminal is a four-wire (isolated) type that is used by connecting to
DP, DN, 24V, and 0V.
■Included wire details
Line color
Details
Red
DP
: Transmission line (+)
Black
DN
: Transmission line (-)
Green
24V
: Unit drive power supply (+)
White
0V
: Unit drive power supply (-)
(Connection example using link connector)
■Power supply to the entire system
Master unit
DP, DN
24V, 0V
FK4-125-100
LP4-WR-10P
To LP4-WW-10P crimped
transmission line link connector
■Local power supply
Master unit
DP, DN
Local power supply
24V, 0V
FK4-125-100
LP4-WR-10P
DP, DN
To LP4-WW-10P crimped
transmission line link connector
■Link connector pin layout
Pin number Details Line color
1
DN
Black
2
DP
Red
3
0V
White
4
24V
Green
[Base unit
transmission line color]
[Base unit
transmission line color]
DP
: Red
DN
: Black
24V
: Green
0V
: White
The LP connector (link connector) is a
mixed-contact type connector.
You can link connectors of the same
type to one another to easily perform
"connections" or "branching."
[Fiber connection]
Fiber diameter (mm)
φ2.2
φ1.0
■If mounting directly: Fiber diameter φ2.2
Press down the knob for the ber port on the ampli er side, fully
insert the ber into the ber port, then return the knob upward.
Knob
■If mounting through an attachment: Fiber diameter φ1.0
Press down the knob for the ber port on the ampli er side, fully
insert the ber into the ber port, then return the knob upward.
Purchase the Omron thin ber attachment E39-F9 separately.
■Cutting of fiber
Cut the ber using the ber cutter included with the ber head.
When doing so, pass the ber through a hole suitable for the ber
diameter and cut at a right angle.
Do not use a hole that has already been used again.
* One ber cutter (B289-FC) is included with each AnyWireASLINK ber head
(AFT-4, AFT-1, AFT-2, AFT-1-1).
CAUTION
！
-L*F1011 6/11-
Installation method
Direct
Use with attachment (E39-F9)
Fiber port
Attach to the ampli er with the tip of
the ber sticking out approx. 0.5mm
0.5mm
beyond the tip of the attachment.
Fiber cutter
B289-FC *
When reusing a fiber that has already been mounted,
cut the tip of the fiber again.
Failure to do so may lower the amount of light emitted
and received.