Danby DDW2405BL Handleiding voor installatie-instructies - Pagina 11
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Danby DDW2405BL. Danby DDW2405BL 13 pagina's. Built-in
Ook voor Danby DDW2405BL: Handleiding voor installatie-instructies (13 pagina's)
Pagina afdrukken
INSTALLATION
INSTRUCTIONS
STEP 13 CONNECT POWER SUPPLY
• Remove junction box Cover "A ".
• Locate the three dishwasher wires,
(white, black and
green) with stripped ends. Insert dishwasher wires
through the small hole in the junction Box" B ".
• Secure house wiring to the bottom of the junction box
with a strain relief" C "
• Use wire nuts to connect incoming ground to green,
white to white and black to black" D ".
• Replace junction box cover"
E ", check to be sure that
wires are not pinched under the cover.
A
Remove
Junction Box
Cover
_
',-
Wire Nuts
E.
Replace
Junction Box Cover
Figure 23
B Check That White, Black and
Green DishwasherWires Are Threaded
Thru H01ein Back
/ /White Black
C
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
WARNING
If house wiring is not 2-wire with
ground, a ground must be provided
by installer. When house wiring is
aluminum, be sure to use UL listed
antioxidant compound and aluminum
to copper connectors.
STEP 14 PRE-TEST CHECK LIST
Review this list after installing your dishwasher
to avoid charges for a service call that is not
covered by your warranty.
[]
Check to be sure Power is OFF.
[]
[]
Open door and remove all foam and paper
packaging.
[]
Locate the Owners manual in the literature
package.
[]
Read the Owners manual for operating instruc-
tions.
[]
Check door opening and closing.
If door does
not open and close freely or tends to fall,
check spring adjustments.
See Step 1.
Check to be sure that wiring is secure under
the dishwasher, not pinched or in contact with
door springs or other components.
See Step
9.
[]
Check door alignment with tub. If door hits
tub, level dishwasher.
See Step 10.
[]
Pull lower rack out, about halfway. Check to
be sure it does not roll backward or forward on
to the door. If the rack moves, adjust leveling
legs. See Step 10.
r]
Check door alignment with cabinet.
If door hits
cabinet, reposition or re-level dishwasher.
See
Step 10.
[]
Verify water supply and drain lines are not
kinked or in contact with other components.
Contact with motor or dishwasher frame could
cause noise. See Step 8.
[]
Turn on the sink hot water faucet and verify
water temperature.
Incoming water tempera-
ture must be between 49oc (120OF) and
65.5°C (150°F). A minimum of 49°C tempera-
ture is required for best wash performance.
See " Prepare Hot Water Line", page 4.
r]
Add two quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
[]
Turn on water supply.
Check for leaks. Tighten
connections if needed.
[]
Remove protective film if present from the con-
trol panel and door.
10