Dancing Wings Hobby 1.8M 1:5 Savage Bobber Gebruiksaanwijzing - Pagina 4
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dancing Wings Hobby 1.8M 1:5 Savage Bobber. Dancing Wings Hobby 1.8M 1:5 Savage Bobber 8 pagina's. Balsawood scale airplane
Pagina afdrukken03-6
03-7
03-8
自攻螺丝
Self-tapping screw
M3x10mm
03-9
舵臂上安装快装接头，然后安装连杆连接舵臂与副翼上舵角，调整到合适位置后，
缩紧快装接头螺丝固定住连杆。
Install the EZ-connector on the rudder arm, and then install the connecting
rod to connect the rudder arm and the upper rudder horn of the aileron.
After adjusting to the proper position, tighten the screw of EZ-connector to
fix the connecting rod.
5
从机翼上取下舵机仓盖板， 粘贴辅助
木块， 把舵机安装到木块之间。
Remove the servo compartment
cover from the wing,
and install the servos between
the small wooden blocks.
舵机线导出孔
Servo line export hole
把舵机线导入机翼内，从机翼侧面导出，两个舵机相同操
作
Guide the steering servo line into the wing and lead it
out from the side of the wing. The two steering
servos operate the same.
连杆夹头安装方法：
Connecting rod collet installation method
1. 打开连杆夹头， 扣住舵角。
Open the connecting rod collet
and buckle the rudder horn.
2. 然后按紧夹头， 再用热缩管固定
住夹头并加热缩减。
Then press the collet tightly, fix
the collet with heat shrinking
tube.
副翼，襟翼连杆安装方法相同。
Connecting rod installation for aileron and flap
in the same way.
03-10
安装机翼斜撑
03-11
Install the wing strut
细节2
螺丝M3*15mm+自锁螺母
Detail 2
Screw +Self-locking nut
螺丝M3*15mm+自锁螺母
Screw +Self-locking nut
SCG33-G
注意：左右机翼相同安装，按以上步骤完成另一边机翼安装
Note: the left and right wings are installed in the same way. Follow the above
steps to complete the installation of the other wing.
03-12
碳管
carbon tube
Ø6x145mm
舵机线穿过
03-13
Servo wire goes through
安装机翼插入碳管内，注意对接2个碳管。舵机线穿过预留孔。
Install the wing and insert it into the carbon tube, pay
attention to butt the two carbon tubes,the servo wires pass
through the reserved hole.
细节1
Detail 1
SCG33-G.1
SCG33-G.2
SCG33-G
细节3
Detail 3
SCG33-G
碳管
carbon tube
Ø14x660mm
03-14
拧紧上图两个螺丝固定住两边机翼。
Tighten the two screws in the picture above to fix the
wings on both sides.
螺丝
Screw
M3*10mm
螺丝
Screw
M3*10mm
手拧螺丝
screw
M4x40mm
6