Dancing Wings Hobby SCG40 Gebruiksaanwijzing - Pagina 5
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dancing Wings Hobby SCG40. Dancing Wings Hobby SCG40 8 pagina's. Balsawood scale airplane arf
Pagina afdrukken04
Install the rudder steering gear and connecting rod
04-1
Q2 Wooden rod
P
04-2
04-3
Assemble the rudder
arm as shown
Install the servo in the servo
position and fix it with screws.
M3*18mm+Self-locking nut
04-5
Alu. buckle
wire penetration
M3*15mm+Self-locking nut
The other end of the steel wire is connected to the servo arm
of the rudder as shown in the figure.
Two steel wire connecting rods are installed in an X-shaped
cross.
7
Install the servo seat at the
corresponding position in
the picture, fix the reverse
Epoxy glue
side with wooden rod and
black tie, and fix it with a
large amount of epoxy
resin adhesive.
P
Black
cable ties
Epoxy glue
Q2 Wooden rod
wire penetration
Install the servo arm on the servo and fix it with screws.
And install the steel wire stay wire.Here are 2 steel wires
controlling the steering rudder.
The two steel wire connecting rods are installed in the same
way, and the wires are kept tight after installation.
05
Install the elevator steering gear and connecting rod
05-1
05-2
Alu. buckle
Lead in servo wire
Install the servo in the servo hole of the horizontal tail and install
the servo arm. The servo wire is led into the conduit placed in the
previous step and led out from the other end. The left and right are
the same.
05-4
Connect the connecting rod to the servo arm, and tighten the
screws to fix it.
Place a conduit inside the fuselage as shown
in the figure on the left, the conduit is spliced
by three short tubes. Fix it on the fuselage
frame with a tie.
Black cable ties
Black cable ties
05-3
Install the connecting rod on the servo arm and rotate the
connecting rod to adjust to the proper length
05-5
The left and right servo control groups are installed in the same
way.
8