Anzzi BA-LMDFVCB007AL Installatie- en bedieningshandleiding - Pagina 4

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Anzzi BA-LMDFVCB007AL. Anzzi BA-LMDFVCB007AL 8 pagina's. Led mirror

Anzzi BA-LMDFVCB007AL Installatie- en bedieningshandleiding

INSTALLATION INSTRUCTIONS

Please read carefully and save these instructions.
Don't discard any of the packaging until you are sure that you have all of the parts and the fittings.
Make sure power to the junction box is off before commencing installation.
IMPORTANT
 Unpack LED cabinet. DO NOT lay cabinet on tiled or concrete surface prior to installation.
Cabinet must be on protected surface to prevent chipping of the corners.
 Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may
be concealed.
 A certified electrician must perform all work. The mirror must be connected to a GFI.
INSTALLATION
Please refer the installation diagram on next two installations manual.
1) Unpack the LED medicine mirror and prepare tools needed. (See Pic.1)
2) Make sure the measurement on the carboard screw holes are matching up with aluminum base
on the mirror back, then mark the screw holes according from the carboard with pencil.(See
Pic.2)
3) Drill holes, and put in the plastic expansion bolt, then fix the aluminum bar by screws.
(See Pic.3&Pic.4);
4) Connect hardwire to power line. Make sure the power off(Voltage:AC110-120V, 50/60Hz).(See
Pic.5)
5) Hang the cabinet on the wall; don't remove your hands until its safety. (See Pic.6)
6) According to your needs, put metal buckles into cabinet holes in suitable height, then install the
glass shelves. (See Pic.7&Pic.8)
7) Find the correct door panels by referring to drawings.Place the door panel on the side panel of
the cabinet. Secure the hinges on the system holes of the side panels of the cabinet , then install
a buffering hinge on each of the two cabinet panels.(See Pic.9&Pic.10)
8) Connect the DC line of the cabinet door panel to the electrical box .(See Pic .9)
9) Connect the lower end of wall with the cabinet body by using the corner brace.(Pic .11)
FUNCTION DESCRIPTION
Turn the light and anti-fog function by the dimmable sensor switch , see details as below:
Button:
a) Touch the button for LED light and anti-fog control;
b) Long press button for dimming. It will change the LED brightness from 10%-100%.

MAINTENANCE

Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not apply directly to mirror.
Never use abrasive cleaners as these could damage the finish or exposed LEDstrip
Apply to the below style of LED medicine cabinet
2