Duevi VV-ZELA-RB Installatie- en gebruikshandleiding - Pagina 6
Blader online of download pdf Installatie- en gebruikshandleiding voor {categorie_naam} Duevi VV-ZELA-RB. Duevi VV-ZELA-RB 8 pagina's. Bi-directional wireless battery siren
Pagina afdrukken
6. VISUAL FEEDBACK
SIREN
1 long flash
1 long flash + 1 short flash
1 long flash + 2 short flashes
1 long flash + 3 short flashes
3 short flashes
7. MAINTENANCE
By sending to the control panel this command, the siren enter in "maintenance" mode" allowing to open the cover without tamper alarm.
Start maintenance: when the siren receives the "start maintenance" radio code, emits some "beep" and blinks indicating that now it is
possible to open the cover without tamper alarm. The max time available is about 4 minutes.
Stop maintenance: when the siren receives the "stop maintenance" radio code, enable the tamper control, emits some "beep" and blinks
long one time.
8. TAMPER
The tamper alarm is active 24 H/24, also at system disarmed (excluded the case of "maintenance" function).
When the siren cover opens, the tamper radio code is sent to the control panel and both start to sound.
Once the tamper alarm is send, it is disabled until the next ARMING of the system.
Thus, in case of tamper alarm, remember that – to enable it again – it is necessary to arm at least one time the alarm system.
Note: when the siren is new or after a RESET, to enable the tamper it is necessary to arm at least once time.
Note: the tamper switch is used to start the "by detection" learning when DIP2 = ON.
To disable the tamper, short the tamper terminals with a piece of wire.
9. LOW BATTERY
The siren signals its battery level is under the minimum threshold by a quick blinking of the LEDs for some seconds at disarming (after the
three blinks for "disarming" feedback).
The siren sends a special "low battery" radio code (LWB) to the control panel, which perform proper actions (visualization on display and
sending of SMS).
10. WARNINGS
BEFORE TO INSTALL THE SIREN, VERIFY THE RADIO RANGE OF THE CONTROL PANEL FROM THE INSTALLATION
POSITION.
THE INSTALLER MUS FOLLOW CURRENT REGULATION
CE100-8 / CE100-3GSM
Total arming
Partial 1 arming
Partial 2 arming
Partial 3 arming
Disarming
6
CE60-3GSM
Total arming
Partial arming
Outdoor arming
-
Disarming