Dancover ST18098 Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} Dancover ST18098. Dancover ST18098 7 pagina's. Garage

4. Assembly of legs

a) Insert (No.1) legs into an end arch one side at a time.

b) Insert (No.2) legs to the second arch.

c) Add second arch to assembly connecting (No.8) into (No.7) and

diagonal bar (No.6) with screws 2 ½" (No.15) with wing nuts

(No.16). See sketch at front page. Note: (06-374) should be

placed at last section.

d) Repeat step b) and c) until the whole shelter is completed.

e) Make sure the base is open to 8' 2".

f) Make sure the distances AD and BC have exactly the same

length as per illustration, lengths depends on the model.

5. Cover installation (Ties are always on the inside)

a) Place the roof in front of the shelter as illustrated.

b) Unfold as illustrated then lift onto shelter as is.

c) Place cover over the completed structure making sure that the

TRIANGLE

is at the front of the garage.

d)Lace rope through grommets and around pipes tightly going

completely around the garage. Grommets are placed in the upper

corner of each door. Put the remaining cord through these

grommets and secure to the ground with nails.

e) Tie firmly inside ties to bars.

6. Door Assembly

a) Take one door with shiny side facing outside placing on to

hooks (No.13).

b) Repeat a) for the remaining doors.

c) Take the elastic, put it through one of the grommet holes on the

door from the inside out. Take S hook, place it on the elastic and

squeeze one end with a pair of pliers so it locks on the elastic.

Repeat until all the elastics are done, and then use the open end

to hook on the grommet band of the roof.

7. Anchoring garage.

a) Place your garage in the final position you want then close the

doors, front and back if supplied before anchoring, anchor with

brackets (No.9) and nail (No.10) as per diagram on the first

page. Drive anchor into ground.

b) Fix flap to your house (if applicable).

8'2