Dugena DCF-77 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dugena DCF-77. Dugena DCF-77 11 pagina's. Radio-controlled clocks

Pagina afdrukken

8. Transmitter call

Hold down the 'Rec' button on the rear of your radio-controlled wall

clock for longer than 3 seconds. All hands will be stopped. First the se -

conds hand, and then the hour and minutes hand will move in overdrive

to the 12 o'clock position. Your radio-controlled wall clock will now

begin to receive the radio signal again. Once the radio signal is success-

fully received, the hands will automatically be set to the current time.

9. Changing the battery

1. Remove the spent battery.

2. When the battery is removed, all of the radio-controlled wall clock's

settings are lost.

3. Insert a 1.5 V LR 6 alkaline mignon battery according to the polarity

marking (+/–) in the battery compartment.

Note:

Please follow the battery regulations.

Spent batteries must not be disposed of in household rubbish. Please

hand spent batteries to your local dealer, a public hazardous waste site

or battery collection point. Never open, short-circuit or throw spent bat-

teries into the fire. Please use a new 1.5 V LR 6 alkaline mignon battery.

If you do not comply with these regulations, batteries may be dischar-

ged via your phase-to-earth voltage, resulting in a risk of leakage.

Should the batteries in your clock leak, remove them immediately to

prevent damage to the clock. Avoid contact with skin, eyes and mucous

membranes. On contact with battery acid, rinse the affected area tho-

roughly with water and/or seek medical advice.

Keep batteries out of the reach of children.

10. Possible sources of interference to radio reception

Problem

Cause

The radio signal for

Storms or metallic

the time cannot be

structural elements in

received.

buildings.

Household equipment

without interference

suppression as well as

TVs, PCs and monitors.

Within an interference

range of approx. 2 m

around the equipment

specified above, your

radio-controlled wall-

clock can no longer

receive the time in -

formation.

Solution

In the interests of

clear reception, your

radio-controlled wall

clock should not be

positioned in direct

proximity to possible

sources of interfe-

rence.

Change the position

of your wall clock.

Remove the battery

for a short time and

then replace it.