Addictive audio B250.4 Handleiding voor eigenaar en installatie - Pagina 10

Blader online of download pdf Handleiding voor eigenaar en installatie voor {categorie_naam} Addictive audio B250.4. Addictive audio B250.4 15 pagina's.

Pagina afdrukken

11. 0-180 Degree Phase Alignment

Allows for the time correction of music signals to prevent phasing

cancellation or music blurring.

12. Power / Protection LED

POWER LED: Will illuminate GREEN when +12VDC is applied to both the remote turn on

PROTECTION: Will illuminate RED when any one of the following occurs:

13. Variable Crossover Control

Adjust both the HPF and LPF crossover frequencies between 40-400Hz

based upon which MODE is chosen in #14 below.

14. MODE

HPF: Set the MODE SWITCH to the HPF position when the amplifier is used to drive a

LPF: Set the MODE SWITCH to the LPF position when the amplifier is used to drive a

FLAT: Set the MODE SWITCH to the FLAT position when the amplifier is used to drive full-

15. Rear RCA Line Input Jacks

Input signal from source unit through RCA cable for the rear channels.

and +12V input from the battery and a solid ground has been made. The input

from the battery to the amplifier can be more than 12VDC.

Short Circuit (Immediately)

Reverse Voltage (Immediately)

Thermal (On at 141*F or 60*C)

Low Voltage (On at 9VDC)

High Voltage (On at 18VDC)

tweeter/midrange system. The frequencies below the crossover point will be

attenuated at -12dB/octave slope. Adjust the crossover frequency by rotating #13

above knob to the desired frequency ranging from 40-400Hz.

subwoofer system. The frequencies above the crossover point will be attenuated

at -12dB/octave. Adjust the crossover frequency by rotating #13 above knob to the

desired frequency ranging from 40-400Hz.

range speakers and/or components that come with their own crossover. The full

frequency bandwidth will be output to the speakers without high or low frequency

attenuation.