Addis TK-13-3.5L Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Addis TK-13-3.5L. Addis TK-13-3.5L 9 pagina's.

Pagina afdrukken

hOw TO OpERATE ThE ADDIS ThERmO pOT...

OpENINg ThE TOp LID

Push down the front edge of the 'top cover lock flap' located on the lid. Lift up the back

portion by pulling upwards to open the top cover. Beware as water may still be hot

and hot steam may escape.

REmOvINg ThE LID (when required)

Lift the top lid to about a 45º angle, press the 'unlock' button located at the rear

of the top cover and pull upwards at 45º.

FILLINg

1. Open the top cover as per the above instruction (no need to remove it), and using

another container (such as a jug) pour cold water into the inner pot until the 'full'

mark is reached (on the inside of the boiler). Do not overfill as hot water may

splash out during boiling. This appliance should never be filled directly from the

tap when it is connected to the mains supply. The power input socket on the

Thermo pot must never come into contact with any water or other liquid.

2. Close the top cover and ensure that the lid is secured by pressing firmly down

until a 'click' sound is heard.

3. When filling the ADDIS Thermo pot always keep the lid away from you as there is

hot steam trapped under the lid.

4. The Thermo pot has a 360º rotating base to assist with ease of access.

5. The lid is an important part of the Thermo pot. If it becomes worn or damaged

contact the supplier for a replacement lid.

BOILINg ThE wATER

After the power is switched on, the water will start to boil automatically.

• Do not open the top cover when the water is boiling

• Do not add water when appliance is still boiling

• Do not obstruct the top lid steam vent

A beeper will sound 5 times when the water is boiled. The keep warm LED will then be

lit and the water will keep warm at the chosen temperature.

Boiling LED is lit

LcD indicates water

temperature

USINg ThE kEEp wARm TEmpERATURE SETTINg

Press the 'SELECT' button to select your ideal temperature. The default setting is 98ºc.

press 'SELEcT' button once

98°c

85°c

to change temperature

• When the keep warm settings are set at 98ºc, 85ºc, 60ºc, 50ºc & 40ºc the keep

warm LED with be lit after boiling

• When the water temperature drops below the selected settings by more than 3ºc, the

water will be reheated to the desired temperature automatically

• The temperature can be reset at any time during keep warm phase

• After the Thermo pot has been disconnected from the mains it is important to check

that your chosen temperature setting has been re-selected when it is reconnected to

the power supply. The Thermo pot will default to the

98ºc setting.

ownERs GUIDE | THERmo PoT

keep warm temperature

selection, keep warm LED lit

60°c

50°c

40°c