Duke E SERIES Installatie-, bedienings-, onderdelen- en onderhoudshandleiding - Pagina 10
Blader online of download pdf Installatie-, bedienings-, onderdelen- en onderhoudshandleiding voor {categorie_naam} Duke E SERIES. Duke E SERIES 15 pagina's. Electric convection oven e - series
Pagina afdrukken
D.
Cleaning of the Ovens
The stainless steel on your oven can be kept clean
with a good stainless steel cleaner, many of which are
on the market. The painted surfaces should be wiped
clean regularly with a MILD detergent. Moisten a
cloth and wipe down the oven while it is COLD.
Wiping down an oven while it is hot will cause
streaking and otherwise unsatisfactory results. Once
the oven is clean it can be wiped down with a light
oil.
Porcelain oven interiors should be cleaned regularly
using a
degreasing
agent. For heavier deposits a
commercial oven cleaner such as
Easy-Off,
or Mr. Muscle can be used. Care must be
taken to prevent these alkaline-type cleaners from
coming in contact with any
in the oven, including the blower wheel.
The blower wheel, racks and rack supports can be
removed and soaked in a solution of ammonia and
water.
Make certain that all parts are thoroughly rinsed
before returning to use.
Blower Wheel
MAINTENANCE INSTRUCTIONS
These maintenance instructions are for the use of
qualified service personnel only. Service by other
than qualified personnel may result in damage to the
oven and/or injury to the operator.
Qualified service personnel are those individuals,
firms, companies or corporations which either in
person or through an agent are engaged in and
responsible for repair or servicing of commercial
Dow
Oven Cleaner,
aluminized
steel surfaces
food preparation equipment, who are experienced in such
work, familiar with all precautions required, and have
complied with all requirements of state and local
authorities having jurisdiction.
If you should require assistance in the selection of a
qualified
service
agency,
Manufacturing
Co.'s
Service Department at 800-735-3853.
Adjustments
Quite often malfunctions which are attributed to defects
may be repaired by adjusting certain parts rather than
replacing them.
B. Door Switch Adjustment
You may also wish to adjust the door switch. The door
switch is located behind the combustion compartment
cover, on the right side. The door switch is activated by a
cam which is mounted to the door's hinge pin with a set
screw.
• Open the doors fully.
• Remove the lower cover by removing the four screws
located inside the door opening.
• Position the doors so they are nearly closed but not
latched.
• To adjust the cam loosen the set screw and rotate the cam
until you hear the switch click.
• Tighten the set screw in the cam. Test the door to make
certain the switch will make contact with the doors closed.
• Replace the combustion cover.
CAUTION: The door switch is located in a heated zone. Care
should be taken to avoid burns.
Door Switch Access Panel
10
please
contact
Duke