Duke TSC-6/18M Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} Duke TSC-6/18M. Duke TSC-6/18M 4 pagina's.

Pagina afdrukken

9. Remove the outer 4 corner retaining nuts that

mount the Main Control Module Assembly to

the inner controls panel.

Do not remove the center nuts or PCB cover of the Main Control

Module Assembly. Warranty may be voided if cover has been

removed or tampered with.

Remove Outer

Do not remove

2 Center Nuts

Remove Outer

INSTALLING NEW CONTROL

1. Using proper ESD procedures, remove the

replacement Main Control Module Assembly

from the shipping box. Visually inspect the new

Main Control Module Assembly for damage.

If damage is identified, do not install the new

control and immediately contact Duke Service

Department for instruction.

2. A display glass protector must be removed from

the new Main Control Module Assembly display

glass before installing. The protector is a clear

transparent plastic layer over the glass which is

easily removed by hand. Contact Duke Service if

you have question about the glass protector.

Nuts

Main Controller Replacement Instructions:

3. To prevent static cling between the display

and overlay, lightly dust the display glass with

baby powder or talc powder. Gently remove

powder by brushing with a cosmetic brush (as

shown below). Do not wipe the display with

hands or any cloth as this may scratch the glass.

Additionally, do not put any powder on the

overlay.

Remove the prior / damaged Main Control

Module Assembly from the mounting studs

and place the new replacement Main Control

Module Assembly. Verify the new Main Control

Module display is centered in the control panel

window. Reinstall the 4 retaining nuts and

reconnect the 2 PCB header connections.

5. Repack the prior / damaged Main Control

Module Assembly in the ship packaging for

return shipment to Duke Manufacturing.

6. Remove the ESD Wrist Strap.

7. Turn ON the left side power switch and verify

the LED indicators on the new Main Control

Module PCB Assembly are active (viewed

through the rear cover window. The PCB LED's

will activate as the control boots and while

running. Go to the Troubleshooting Guide if

LEDs do not activate.

TSC-6/18 and PBC-6/18