AOG T series Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} AOG T series. AOG T series 2 pagina's. Post outdoor gas grill
Ook voor AOG T series: Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's)

Pagina afdrukken

Fig. 4-1

Cooking grid

Vaporizer panel

Main burner

Warming

rack

Drip tray

heat shield

Read setting

Read setting here

here

OFF

Fig. 5-1 - Burner valve control knob

WHEN OPERATING THIS

APPLIANCE WITH PROPANE,

ALL INSTRUCTIONS AND

WARNINGS MUST BE

OBSERVED. FAILURE TO DO

SO MAY RESULT IN A FIRE

OR EXPLOSION CAUSING

SERIOUS INJURY OR DEATH.

6-Propane Safety

FOR PROPANE CONFIGURATIONS; READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE

GAS FOUND IN YOUR OWNER'S MANUAL.

REV 1 - 1705101540

Backburner

(if equipped)

5-Test

Note:

DO NOT turn on more than one valve at a time for either electronic or manual lighting.

1. Open lid(s) or remove cover(s) from burner(s) to be lit.

2. Turn all gas control knob(s) to their OFF position(s).

3. Turn on the gas at its source.

4. Depress the desired control knob, then while pressing turn it counterclockwise to the HI LIGHT

position. Once the burner lights, release the knob.

Note:

Turning the knob will create a "click" sound. The pilot will ignite at this point, lighting the burner.

HIGH to

High to

LIGHT

light

CAUTION:

If a burner does not light within two to three (2-3) seconds of turning on the control knob,

depress the knob and turn it to the OFF position. WAIT FIVE (5) MINUTES before

repeating step 4. If you smell gas, follow the instructions on the cover of the grill owner's

manual. If the burners still do not light after several attempts, refer to the grill owner's

manual for manual lighting.

5. Repeat step 4 for each additional burner to be lit.

Fig. 5-2

Left

main burner

control knob

and 36

4-Grill Setup

Parts Placement Checklist

Place the following items according to their position and orientation in

Fig. 4-1:

Vaporizer panels, cooking grids, and warming rack.

Leave pre-installed burners in place to maintain proper alignment.

Vaporizer Panels

Place the vaporizer panels directly onto the studs on the burners.

The panels allow heat from the burners to be evenly distributed

throughout the cooking area.

Cooking Grids

Place the cooking grids (over the burners) onto the grill frame.

Warming Rack

The warming rack comes pre-installed. Remove zip ties before use.

Consult the owner's manual to remove or replace.

Rotisserie kit

(if equipped)

Replacement parts can be ordered

from your local Fire Magic dealer.

Center main burner

control knob

Drip

tray

model controls

The burner ports

and carry-over ports

and carry-over slots

must be kept clean to

ensure proper ignition

and operation.

from your local AOG dealer.

Right

main burner

Backburner

control knob

(if equipped)

Control panel

screw(s)

L-C2-483