AOG 16-39-SSD Specificaties installeren - Pagina 2

Blader online of download pdf Specificaties installeren voor {categorie_naam} AOG 16-39-SSD. AOG 16-39-SSD 6 pagina's. Door & drawer

Pagina afdrukken

For proper installation, be sure to use the correct cutout

dimensions as speciﬁ ed for your model number. Locate your

model on the following pages for dimensions, and reference the

cut-out diagram of your unit for proper orientation.

Important: Doors and drawers are supplied with 8 screws for

installation. If installing into a concrete island, pilot

holes are required.

Important: When installing in an AFD GFRC Island, use the

bracket and screws provided with the island.

DOOR

Slide in and fasten the unit securely into the island enclosure using

the supplied hardware through the installation screw slots in the top

and bottom of the unit.

For doors with propane tank trays:

To use, simply open the door, pull out the sliding cylinder tray, place

your cylinder on the tray and push the tray back in. The cylinder is

now ready for connection to your grill.

Important: Refer to any additional instructions included with

your door for the required installation method of

propane tank cylinders.

DRAWER

Before installing your drawer, remove the drawer from its base by

completely pulling it out. Release the drawer from the drawer slides

by pressing the black lever down on the right side, and up on the left

side (Fig 2-3). Then pull outward on the drawer until it comes free of

the runners.

1. In order to properly support the weight of your drawer, it is necessary

to provide a secure, level surface in the rear of the unit (see Fig

2-4). This may be accomplished by using bricks, 2 X 4's, etc. Be

sure that the height of this rear support is 1 / 8 " higher than that of

the front opening support, so that your drawer sits level.

2. Slide in and fasten the unit securely into the island enclosure

using the supplied hardware through the installation screw slots

in the top and bottom of the unit.

3. To re-attach the drawer; extend the drawer slides completely and

align the drawer into the slides, pushing the drawer closed. Open

the drawer to verify that it has locked in place.

REV 3 - 1812041115

IN S TA L LATION GU IDE LI NE S

Fig. 2-1 Door cut-out diagram

Fig. 2-2 Drawer cut-out diagram

Fig. 2-3 Releasing drawer from slides

Drawer

Front

Side View

Fig. 2-4 Drawer Installation (Side View)

Drawer

support

L-C2-360