dun-bri GROUP 308.HPF306VV Installatie- en bedieningsinstructies - Pagina 3

Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} dun-bri GROUP 308.HPF306VV. dun-bri GROUP 308.HPF306VV 4 pagina's. R65 led warning module

Pagina afdrukken
WIRING INSTRUCTIONS
TO CHANGE FLASH PATTERNS
Momentarily apply yellow wire to the +VDC. A simple momentary switch will be sufficient.
SYNCHRONISATION INSTRUCTIONS
Ensure all modules are set to the same flash pattern. Connect yellow wires of all modules together.
ALTERNATE SYNC INSTRUCTIONS
Ensure all modules are set to the same flash pattern.
Connect yellow wires of all modules together.
For GROUP 1: Connect all white wires to the +VDC.
For GROUP 2: Do not connect white wires.
DIMMER FUNCTION INSTRUCTIONS (HPF307VV VERSION ONLY)
Apply blue wire to the +VDC. A simple latching switch will be sufficient.
MOUNTING + FITTING INSTRUCTIONS
Carefully unpack and inspect the module and all
accessories before installing to ensure there are no
damaged or missing parts.
Use foam gasket and screws provided. Do NOT
overtighten screws.
Plan all cable routing before attempting installation and
ensure voltage compatibility.
Ensure there are no obstructions limiting visibility to
traffic when mounting.
If the module slides or moves easily, a proper installation
has NOT been attained.
MODULE LENS CLEANING
Occasional cleaning is recommended to ensure optimal
light output. Although tough, polycarbonate scratches
easily, so take care when cleaning. Clean lens with soap
and water or a lens polish using a soft cloth.
www.dun-bri.com
Dun-Bri Group, Watermill Industrial Estate, Aspenden Road, Buntingford, Hertfordshire, SG9 9JS, United Kingdom
+44 (0)1763 274185
! WARNING ! - Unconnected
wires MUST be sealed to
prevent any water ingress.
! CAUTION ! - Disconnect the
battery before wiring up the
module to prevent accidental
shorting and/or electrical shock.
! CAUTION ! - When drilling into
the vehicle surface, make sure
the area is free from anything
that could be damaged,
including any electrical wires,
fuel lines, upholstery, etc.
! WARNING ! - Do NOT
overtighten screws.
! WARNING ! - Do NOT use
solvents as they may damage
the lens.