Danfoss iC7 Series Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss iC7 Series. Danfoss iC7 Series 6 pagina's. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Ook voor Danfoss iC7 Series: Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (10 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (18 pagina's)

Ground Bar Kit for FK11/FB11 and FK12/FB12

Installation Guide

2.3 Installing the Ground Bars

After assembling the ground bars, use the following steps to install them in the frequency converter.

Remove 4 screws from the mounting holes in the midplate, 2 from each side of the frequency converter.

Illustration 2: Location of Ground Bar Mounting Holes in Midplate

Position the 2 angle brackets with attached ground bars over the mounting holes in the midplate.

Fasten angle brackets to the midplate with 4 M5x18 mm screws (T25), 2 in each angle bracket.

Tighten to 2.3 Nm (20 in-lb).

Installation

AN422349925420en-000101 / 136R0287