Danfoss iC7 Series Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss iC7 Series. Danfoss iC7 Series 10 pagina's. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Ook voor Danfoss iC7 Series: Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (18 pagina's)

In-back/Out-back Cooling Kit for FK11/FB11 and FK12/FB12

Installation Guide

2.5 Installing the Bottom Cover (Before Pedestal)

Use the following steps to install the bottom cover before attaching the pedestal. See

Procedure

Remove paper backing from the bottom gasket.

Adhere the bottom gasket to the upper side of the bottom cover.

Position the bottom cover and gasket over the opening at the lower end of the cooling channel.

Secure the bottom cover using the M5x14 screws (T25) provided with the kit.

Torque screws to 2.3 Nm (20 in-lb). FK11/FB11 frequency converters require 8 screws; FK12/FB12 frequency converters

require 10 screws.

Illustration 4: Installation of Bottom Cover and Pedestal

Cooling channel

Bottom gasket

Bottom cover

Illustration

M5x14 screw

Pedestal

M10x30 fastener

AN361429087579en-000101 / 136R0289

Installation