Danfoss iC7 Series Installatiehandleiding - Pagina 14

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss iC7 Series. Danfoss iC7 Series 16 pagina's. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Ook voor Danfoss iC7 Series: Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (14 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (8 pagina's), Installatiehandleiding (10 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (16 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (6 pagina's), Installatiehandleiding (18 pagina's)

In-back/Out-back Cooling Kit for FA09-FA10

Installation Guide

Secure the M5x18 screws in the flange of the upper back vent, attaching the vent to the back plate.

Use 6 screws for the FA09 frequency converter, and 8 screws for the FA10 frequency converter.

To install the lower back vent, use the following steps.

Slide 6 clip-on nuts over the edge of the lower vent opening in the back plate of the cabinet.

Seat the clip-on nuts into the 6 holes around the opening.

Affix 2 lower vent gaskets to the flange of the lower back vent, placing 1 gasket on the inner side and 1 gasket on

the outer side of the flange.

Slide the lower back vent into the opening in the back plate.

Fasten 4 M6x12 screws around the inner edge of the lower back vent.

Secure the M5x18 screws in the outer flange of the lower back vent, attaching the vent to the back plate.

Use 6 screws for the FA09 frequency converter, and 8 screws for the FA10 frequency converter.

Illustration 11: Installation of Upper and Lower Back Vents

Installation

AN371942471353en-000101 / 136R0248