Dunavox DAUF-40.138SS Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dunavox DAUF-40.138SS. Dunavox DAUF-40.138SS 15 pagina's.
Pagina afdrukken
1.
Remove the door gasket
wish to install the handle - you can see two
designated holes for handle installation.
2.
Install the handle
with two screws
provided.
3.
Replace the door gasket.
Note: All parts removed must be saved to do the
reinstallation of door.
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
DESIGN 1 – For built-under models
1.
Remove the ventilation grille
adjustable ventilation grille
○
the screws
,3 &
some models without adjustable ventilation
grille, the step is not needed.
2.
Remove the bottom hinge
the four lock screws
glass door firmly after removing the screws.
(Fig. 2)
3.
Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
remove the right top hinge
4.
Unscrew and transfer hinge pin
○
door stopper
opposite side. (Fig. 3)
○
on the side you
,1
○
tightly as shown above
,4
○
and flat washers
,3
○
and the
,2
○
by unscrewing
,1
○
. (Fig. 1) NOTE: For
,4
○
,5 by unscrewing
○
,6. Be careful to hold the
○
,9. (Fig. 4)
○
,7 and/or
,8of the bottom hinge to the
5.
Pop out the cover caps on the left side of
cabinet and use them to
on the right hand side.
6.
Screw the alternative left top hinge
○
,2
included in the fittings,
cabinet. (Fig. 4)
7.
Unscrew and transfer the holes cover
and lock catch
glass door. (Only for models with lock on the
ventilation grille) (Fig. 5)
8.
Rotate the door 180° (No need for models with
lock on the door) and relocate the door to the
designated position. Then screw the bottom
hinge assembly on the left designated position
and tighten it after the door is leveled.
9.
Transfer the handles & plugs to the opposite
positions and then reassembly the ventilation
grilles if need.
DESIGN 2 – For fully integrated models
1.
Remove the glass door by unscrewing the eight
lock screws
glass door firmly after removing the screws and
place it on a padded surface to avoid the risk of
damage.
2.
Unscrew and transfer the door supporter
the opposite side.
3.
Rotate the glass door 180°and refit the glass door
to the opposite side. Then screw and tighten it
after the door is leveled.
cover the screw holes
on the left hand side of
○
,13 to the opposite side of
○
○
and
. Be careful to hold the
,3
,4
○
,11,
○
,12
○
,2 to