Dunavox DAVS-72.185 Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dunavox DAVS-72.185. Dunavox DAVS-72.185 16 pagina's.

Pagina afdrukken

Eco Demo mode can be activated by presenting the

appliance at exhibitions or in salesrooms. In Eco Demo

mode, the compressor and all fan motors are switched

OFF.

By pressing and holding the "UP"&"DOWN" (The controls

of lower zone for dual zone & three zone models) and

"LIGHT" keys at the same time for at least 5 seconds,

the indicator light will flash five times to confirm the input

and the unit will operate in Eco Demo mode. Eco Demo

mode can be exited by repeating the above process.

GENERAL INFORMATION

Operating Noises

The unit is cooled by a compressor (refrigeration

aggregate). The compressor pumps coolant through the

cooling system, producing operating noise. Even when

the compressor cuts out, noises caused by changes in

temperature and pressure are unavoidable. Operating

noise will be most audible immediately after the

compressor cuts in. It becomes quieter as the operating

period continues.

The following noises are normal and occur from time to

time:

- Gurgling sound, caused by the refrigerant flowing

through the appliance's coils,

- Humming noise made by the motor compressor. This

noise can get louder for brief periods when the motor

is switching on.

- Cracking/popping sounds, resulting from the materials

contraction and expansion due to temperature

variations,

- Fan operating sound, to circulate the air within the

wine cabinet.

Unusual noise is normally the result of improper

installation. Under no circumstances must tubing come

into contact with a wall, other furniture or with other

tubing.

Where the unit is installed in open-plan kitchen or in

partition walls, the level of operating noise will be heard

more acutely. However, this is due to the surrounding

architecture and not to the unit.

An individual's perception of noise is directly linked to

the environment in which the unit is located, as well the

specific type of models. Our appliances are in line with

international standards for such appliance and in line

with the latest technical developments. But please

remember that the noise of the compressor and the

coolant circulating in the system is unavoidable.

DEFROSTING / HYGROMETRY /

VENTILATION

Your unit is designed with an automatic defrost system.

During the "Off-cycle" the evaporator behind the rear wall

of the unit defrosts automatically. The condensate

collects in the drain trough behind the rear wall of the

unit, and part of it flows through the drainage hole into

the drip tray by/above the compressor. The heat is

transferred from the discharge pipe or compressor and

evaporates any condensation that has collected in the

tray. Part of the remaining water is collected within the

unit for humidity purposes.

This system enables the creation of the correct humidity

level inside your unit required by the natural cork to

maintain a long lasting seal.

The appliance is not totally sealed: fresh air admission is

permitted through the drainpipe. Air is circulated through

the unit by means of a fan / fans and the hollow shelves.

NOTE: Frost may be accumulated on the evaporator if

the unit is repeatedly opened in a high heat or high

humidity location. If this frost pattern does not clear within

24 hours, your unit will require manual defrosting.

CARE AND MAINTENANCE

WARNING: Failure to unplug the appliance during

service and cleaning could result in electrical shock or

other personal injury.

REMOVING SHELVES

To remove any of the shelves from the rail compartment,

move the shelf to the position where the notch of wooden

shelf is exactly under the plastic post and then lift it up

and pull out.

In order to replace the shelf, repeat steps described

above in reverse. And make sure to engage the shelves

with the small pegs of the extended rails when the model

is equipped with roller system.

HUMIDITY CONTROL

The appliance is equipped with a system for maintaining

the correct level of humidity. Under extremely dry

environmental conditions, you may have to add some

water into the humidity box provided with your wine

cellar.

Fill the small plastic reservoir (humidity box) ¾ full with

water, and fit onto the runners found on the top shelf of

the appliance. Check the water level regularly and refill

as necessary.

Please ensure the reservoir is positioned correctly on the

runners on the top shelf to avoid the possibility of water

spillage.