CASI RUSCO 660 Installatiehandleiding - Pagina 11

Blader online of download pdf Installatiehandleiding voor {categorie_naam} CASI RUSCO 660. CASI RUSCO 660 14 pagina's.

Testing the Keypad

Follow the steps below to verify that the keypad is working correctly.

Check all cabling and electrical connections from the keypad to the

microcontroller. See

Wiegand Output," on page 4.

Verify that the microcontroller is properly configured. See the

appropriate CASI-RUSCO microcontroller manual.

Apply power to the keypad and verify that the red LED is on. You

may want to use a multimeter to test the voltage at the keypad's

pigtail connector, using ground as a reference. The power pin, data

lines, and door DO should all read approximately 5V.

Be sure the keypad PIN is properly entered in the host system. The

PIN should be entered as the Badge Number on the Badge Form. The

PIN field can be left blank.

Check that the door is secure. Press the "*" key on the keypad. This

clears out any previous entries. Next, enter the PIN into the keypad.

Finally, press the "#" key for the keypad to accept the PIN. Observe

that the keypad beeps briefly. (For example, if entering the PIN

12345, enter the following: *12345#)

Open the door. This verifies that the door strike operates correctly.

Figure 2, "Wiring Diagram, Model 660 26-bit

Model 660 Keypad