Danfoss CS2 Installatiehandleiding - Pagina 15

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss CS2. Danfoss CS2 16 pagina's. Wireless electronic hot water cylinder thermostat

Pagina afdrukken

Commissioning

If the thermostat CET2000B-RF and receiver RX1-S have been

supplied together in a combined pack, the units have been

paired in the factory and no commissioning is required. If the

thermostat and receiver have been supplied separately follow

the steps below to pair the devices.

Step 1 RX1-S - Ensure RX1-S is wired in accordance with

instructions on page 8.

Step 2 CET2000B-RF - Insert 2xAA alkaline batteries. If the

CET2000B-RF is not already paired to the RX1-S it will enter it's

learning mode shown by the flashing aerial icon.

Step 3 RX1-S - Press and hold down both the PROG and CH

buttons. The PROG LED will light for 1 second when it has

paired with the CET2000B-RF. Release buttons

A steady aerial icon on CET2000B-RF confirms that the devices

are now paired and ready for control of your domestic hot water

system.

Danfoss Heating