Aetina ACE-N622 Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aetina ACE-N622. Aetina ACE-N622 15 pagina's. Nvidia jetson series carrier board

Pagina afdrukken

6. Software & BSP.

When customer use Nvidia standard BSP, some I/O function may not work. In order to

support Aetina ACE-N622 system I/O config, please follow below method.

1. Download Jetpack3.1 from Nvidia website.

https://developer.nvidia.com/embedded/downloads

2. Install JetPack-L4T-3.1-linux-x64.run

=>"Sudo Chmod +x

=>"Sudo

./JetPack-L4T-3.1-linux-x64.run"

3. Select 3 items of Target-jetson TX2, others select "No Action" and go next step.

System will auto download "File System" "OS R28.1" and "Drivers".

After file download, don't flash the image. Close the tool directly.

4. Copy the file to the same folder with "JetPack-L4T-3.1-linux-x64.run" and extract the file

"sudo tar -zxvf R28.1_2.tar.gz -C .

5. Run

"Sudo ./setup.sh tx2

If success, you can see "DONE" message. (64_TX2, 64_TX2_patch, setup.sh should be in the same layer

of folder"

6. Power on system and enter Recovery mode.

7. Run

"Sudo ./flash.sh Jetson-tx2

8. Wait for 15 mins and finish the flash process.

Recovery system

The TX1/TX2 embedded system contains a recovery system and could be triggered by GPIO.

(1) For TX1, shut down the system first and connect the 3V3 pin & GPIO_4 (GPIO 184)

For TX2, shut down the system first and connect the 3V3 pin & GPIO_4 (GPIO 481)

(2) Boot the device,

It will need about 3 minutes for recovering the system.

After finishing, it will shut down the device.

Remove the connected pins and power on the device.

JetPack-L4T-3.1-linux-x64.run"

--numeric-owner"

N622".

mmcblk0p1"

- 11 -