Danfoss SET3M Installatiehandleiding - Pagina 5

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss SET3M. Danfoss SET3M 16 pagina's. Electro-mechanical 24 programmer for heating & hot water
Ook voor Danfoss SET3M: Installatie- en gebruikersinstructies (20 pagina's)

Pagina afdrukken

Outline of

programmer

Leave at least

25mm below

product

Rear entry

cable access

5. Referring to the wiring diagrams on page 6-12, connect the unit as

shown.

6. The unit is supplied ready for use in systems having PUMPED

primaries.

Should the unit be required for use in a system having GRAVITY

primaries, ﬁ t the small plastic shorting link (which can be found

taped below the left hand ﬁ xing screw hole of the wallplate) over

the two pins on the rear of the plug-in module. These pins can

be found in the recess near to the bottom edge of the plug-in

module.

7. Ensure all dust and debris are cleared from the area.

8. Locate the module on the latches at the bottom of the wallplate

and hinge upwards to fully engage the unit connectors into the

wallplate. Tighten the two ﬁ xing screws to secure the unit to the

wallplate.

9. Before setting the programme, check the unit and circuit.

Switch ON the mains supply and press both WATER and

HEATING rocker switches to the CONSTANT position - both red

LED's should now be illuminated. Adjust any remote thermostat

to check the services operate correctly.

Danfoss Heating

C/L

Cable aperture

knockouts

Leave suﬃ cient space

for screwdriver access

Terminal

block

Wall or

plasterbox

ﬁ xing