Danfoss TP5000 RF Si Handleiding voor installatie-instructies - Pagina 10
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Danfoss TP5000 RF Si. Danfoss TP5000 RF Si 14 pagina's. 5/2 day programmable electronic room thermostat
Ook voor Danfoss TP5000 RF Si: Installatie- en gebruikershandleiding (14 pagina's), Gebruiksaanwijzing (2 pagina's)
Pagina afdrukken
- 1. Installation Instructions
- 2. Product Specification
- 3. Installation
- 4. Commissioning (RF Models Only)
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. User Instructions
- 8. Before You Start
- 9. Setting the Clock & Day
- 10. Running Your Programme
- 11. Before You Change the Preset Programmes
- 12. Changing the Preset Programmes
- 13. User Overrides
- 14. Frost Protection
- 15. Battery Replacement
Running your programme
GB
If you are happy to use the preset programmes on page 8, you
don't need to do anything else.
To accept the presets close the front cover
and after 2 minutes the pre settings will
automatically be accepted (& colon will blink).
Your unit is now in RUN mode.
Before you change the preset programmes
Please Note
The unit must be programmed in sequence and ON/OFF
times cannot be programmed out of sequence.
If you want to leave a preset time as it is, simply press PROG
to move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and the
programme set up to that minute will be active.
!
If at any time you get confused and need to reset the unit to
the preset programmes press the + & – AND
simultaneously.
10
i2 24
20
&
buttons