Danfoss APP 30/1 Servicehandleiding - Pagina 4

Blader online of download pdf Servicehandleiding voor {categorie_naam} Danfoss APP 30/1. Danfoss APP 30/1 20 pagina's. Disassembling and assembling

Disassembling and Assembling, APP 21-43

Service guide |

4 | 180R9121 | 521B1018 | DKCFN.PI.013.A6.02

8. Using a 13 mm combination wrench,

remove all the bolts on the mounting

flange except the three shown in the next

picture.

WARNING:

Do not loosen the two screws keeping

swash plate in place.

10. Screw the eye bolt in the M8 hole in the

middle of the flange. Pull it straight

upwards.

12. Remove by hand the pistons one by one.

Be careful not to scratch the pistons. Tilt

the retainer plate to horizontal position for

easy removal of pistons, if required.

WARNING:

Do not use any tools.

9. Unscrew the remaining three bolts. Turn

each bolt one round at the time to make

sure that the flange is removed as straight

forward as possible.

11. Swash plate must be placed so that its

surface is not scratched. For further

disassembling of swash plate, see page 10.

13. Remove the retainer plate and the retainer

ball.

Note: As the retainer ball is not attached

to the retainer plate, it might fall out.