Dunlop AKIRA TAKASAKI CRY BABY FUZZ WAH Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Dunlop AKIRA TAKASAKI CRY BABY FUZZ WAH. Dunlop AKIRA TAKASAKI CRY BABY FUZZ WAH 5 pagina's.

Pagina afdrukken

BASIC OPERATION

POWER

The Cry Baby

Akira Takasaki Fuzz Wah is powered by one 9-volt

battery (accessed via underside of pedal), the Dunlop ECB003 9-volt

adapter, or an MXR

Brick

Series power supply.

™

OPERATION

1. Run a cable from your guitar to the AT95M's INPUT jack and run

another cable from the AT95M's OUTPUT jack to your amplifier.

2. Push the FUZZ ON/OFF switch IN to engage the fuzz effect,

indicated by rear green LED. To disengage fuzz mode, push the

switch again to its OUT position.

3. Rotate the FUZZ SENSITIVITY knob clockwise to increase fuzz

intensity or counterclockwise to decrease it.

4. To access the internal FUZZ VOLUME control, remove the bottom

plate. Rotate the internal FUZZ VOLUME knob clockwise to increase

overall volume when the fuzz mode is engaged or counterclockwise

to decrease it.

5. This pedal is bypassed (off) while your foot is off the rocker. To

engage the wah effect, simply press the toe of the pedal down with

your foot. Rear blue LED will illuminate when wah effect is engaged.

6. To increase rocker effect ring-out time, rotate external BYPASS

DELAY knob with center detent counterclockwise. To decrease effect

ring-out time, rotate the knob clockwise.

AT95M CRY BABY

AKIRA TAKASAKI FUZZ WAH