Danfoss 176F4045 Installatiehandleiding - Pagina 9

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Danfoss 176F4045. Danfoss 176F4045 16 pagina's. In-back/out-back cooling kit for fa09-fa10, frequency converters

Pagina afdrukken
In-back/Out-back Cooling Kit for FA09-FA10
Installation Guide
1
2
3
4
Illustration 7: Installation of the Top Cover
1
M5x14 screws
2
Top cover

2.6 Mounting the Frequency Converter

To install the mounting plate and frequency converter in the Rittal cabinet, use the following steps. Refer to
Procedure
1.
Remove the backing paper from the 2 self adhesive upper mounting plate gaskets.
2.
Affix the gaskets around the upper opening, 1 on each side of the mounting plate.
3.
Remove the backing paper from the 2 self adhesive lower mounting plate gaskets.
4.
Affix the gaskets around the lower opening, 1 on each side of the mounting plate.
5.
Attach the mounting plate to the cabinet rails, making sure that the pem studs face the front of the cabinet.
6.
Remove the backing paper from the 2 seal plate gaskets.
7.
Affix the gaskets to the seal plates, 1 per plate.
8.
Fasten 2 M10x30 screws through the seal plates, 1 per plate, and into the M10 nuts at the lower end of the mounting plate.
Check that the screws are secure. The base of the frequency converter rests on the screws.
9.
Slightly lean the top of the frequency converter forward and set the notches in the base onto the 2 screws.
10.
Slowly push the top of the frequency converter back against the mounting plate until the top 2 pem studs line up with the
holes in the frequency converter.
11.
Secure the top of the frequency converter using 2 M10 nuts.
Torque all fasteners to 19 Nm (170 in-lb).
Danfoss A/S © 2022.03
3
Top cover gasket
4
Top vent
AN371942471353en-000101 / 136R0248 | 9
Installation
Illustration
8.