Casio CFX-9950GB PLUS Functiehandboek - Pagina 14

Blader online of download pdf Functiehandboek voor {categorie_naam} Casio CFX-9950GB PLUS. Casio CFX-9950GB PLUS 14 pagina's. 6. matrix calculations
Ook voor Casio CFX-9950GB PLUS: Software Handleiding (20 pagina's), Gebruikershandleiding (18 pagina's), Communicatiehandleiding (13 pagina's), Programma-handleiding (18 pagina's), Lees deze eerste handleiding (13 pagina's), Grafiek Handleiding (8 pagina's), Grafiek Handleiding (6 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (10 pagina's), Handleiding voor berekeningen (13 pagina's), Handleiding voor berekeningen (18 pagina's), Handleiding voor berekeningen (15 pagina's), Complexe getallen handleiding (6 pagina's), Handleiding voor berekeningen (6 pagina's), Handleiding voor berekeningen (20 pagina's)

10 - 2

Graphing with the Sketch Function

u u u u u To check the on/off status of a pixel

While the sketch menu is on the screen, press 6 (g) 6 (g) 4 (Test) and then

input the command shown below to check the status of the specified pixel. 1 is

returned when the pixel is on, and 0 is returned when the pixel is off.

k k k k k Clearing Drawn Lines and Points

The following operation clears all drawn lines and points from the screen.

u u u u u To clear lines and points in the STAT, GRAPH, TABLE, RECUR and

Lines and points drawn using sketch menu functions are temporary. Display the

sketch menu and press 1 (Cls) to clear drawn lines and points, leaving only the

original graph.

u u u u u To clear drawn lines and points in the RUN or PRGM Mode

The following is the syntax for clearing drawn lines and points, as well as the

graph itself.

166

PxlTest <line number>, <column number>

• Specify a line in the range of 1 to 63 and a column in the range of 1 to 127.

• Trying to perform one of the above operations without specifying a line and

column number results in an error.

• Pixel operations are valid only within the allowable line and column ranges.

CONICS Modes

Cls

[Sketch]-[Test]

[Sketch]-[Cls]