Casio fx-9750G PLUS Functiehandboek - Pagina 7

Blader online of download pdf Functiehandboek voor {categorie_naam} Casio fx-9750G PLUS. Casio fx-9750G PLUS 14 pagina's. Graphing calculator
Ook voor Casio fx-9750G PLUS: Productcatalogus (16 pagina's), Communicatiehandleiding (13 pagina's), Programma-handleiding (18 pagina's), Lees deze eerste handleiding (13 pagina's), Grafiek Handleiding (8 pagina's), Grafiek Handleiding (6 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (12 pagina's), Grafiek Handleiding (10 pagina's), Handleiding voor berekeningen (13 pagina's), Handleiding voor berekeningen (18 pagina's), Handleiding voor berekeningen (15 pagina's), Complexe getallen handleiding (6 pagina's), Handleiding voor berekeningen (6 pagina's), Handleiding voor berekeningen (20 pagina's), Gebruikershandleiding (13 pagina's)

1. After entering the RUN Mode, display the sketch menu and perform the

following operation.

!4(Sketch)6(g)

1(PLOT)1(Plot)c,c

2. Press w and the pointer appears on the display. Press w again to plot a

point.

• You can use the cursor keys to move the pointer around the screen.

• If you do not specify coordinates, the pointer is located in the center of the

graph screen when it appears on the display.

• If the coordinates you specify are outside the range of the View Window

parameters, the pointer will not be on the graph screen when it appears on

the display.

• The current

- and

X and Y.

k k k k k Turning Plot Points On and Off

Use the following procedures to turn specific plot points on and off.

u u u u u To turn plot points on and off in the STAT, GRAPH, TABLE, RECUR

and CONICS Modes

• To turn a plot point on

1. After drawing the graph, display the sketch menu and press 6 (g) 1

(PLOT) 2 (Pl·On) to display the pointer in the center of the screen.

2. Use the cursor keys to move the pointer to the location where you want to plot

a point and then press w.

• To turn a plot point off

Perform the same procedure as described under "To turn a plot point on" above,

except press 3 (Pl·Off) in place of 2 (Pl·On).

• To change the on/off status of a plot point

Perform the same procedure as described under "To turn a plot point on" above,

except press 4 (Pl·Chg) in place of 2 (Pl·On).

Graphing with the Sketch Function

-coordinate values are assigned respectively to variables

[Sketch]-[PLOT]-[Pl·On]/[Pl·Off]/[Pl·Chg]

10 - 2

159