Free The Tone TRI AVATAR Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Free The Tone TRI AVATAR. Free The Tone TRI AVATAR 8 pagina's. Multi-dimensional chorus

Pagina afdrukken

Realtime parameter control via expression pedal

An expression pedal connected to the EXP terminal can be used to control the RATE (modulation speed) or

TONE parameter in realtime.

Controlling RATE parameter

1. Turn the RATE knob clockwise or counterclockwise while holding down the ON/OFF and PRESET

switches.

2. When the EDIT LED flashes twice, then the setting is completed.

NOTE

The initial setting at factory before shipping is to control the RATE parameter.

Controlling TONE parameter

1. Turn the TONE knob clockwise or counterclockwise while holding down the ON/OFF and PRESET

switches.

2. When the EDIT LED flashes twice, then the setting is completed.

NOTE

Please refer to the Free The Tone website for recommended expression pedals.

Configuring MIDI settings

The TRI AVATAR can switch presets and change each parameter by MIDI signals received from an external

controller.

Changing MIDI reception settings

1. While holding down the PRESET switch, turn on the power to the TRI AVATAR. Keep the switch pressed

until both the PRESET and MANUAL LEDs illuminate.

2. When both the LEDs illuminate, release the PRESET switch.

3. Press the ON/OFF switch to toggle the MIDI reception settings.

NOTE – Meaning of the ON/OFF LED statuses:

• The ON/OFF LED illuminates: Omni mode is turned on. All of the MIDI channels will be accepted.

• The ON/OFF LED is flashing: Omni mode is turned off. Refer to "Setting MIDI receiving channels" (p.9).

• The ON/OFF LED is turned off: MIDI receiving function is turned off.

Setting MIDI receiving channels

1. While holding down the PRESET switch, turn on the power to the TRI AVATAR. Keep the switch pressed

until both the PRESET and MANUAL LEDs illuminate.

2. When both the LEDs illuminate, release the PRESET switch.

3. Press the ON/OFF switch to flash the ON/OFF LED.

4. Press the PRESET switch to select the receiving channel while referring to the table on the next page

(Correspondence between MIDI receiving channels and PRESET LED indications).

5. Press the MODE switch to end the operation.