DUOTONE DAYTONA DOS 2021 Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DUOTONE DAYTONA DOS 2021. DUOTONE DAYTONA DOS 2021 14 pagina's. Hydrofoil

3.2.

ASSEMBLING THE HYDROFOIL

1. Use the screws provided to screw the glider to the mast.

2. Make sure no sand or other dirt is in the inserts.

3. Hold the glider with the fuselage against the connection area on the mast and slide the three M6x40mm

screws through the fuselage. Finally, screw these into the mast.

4. Insert the fourth M6x25mm screw through the fuselage, and screw this firmly into the mast.

5. Insert the upper end of the mast into the tuttle box on the hydrofoil board.

6. We recommend using two screws to attach your foil to the board in the following manner.

a. Use at least the inserts 1 & 5 to attach the foil to your board. Make sure the screws have been rotated at

least 6 times when screwing them tightly into the insert. Check that the screws are not too long to avoid

damage to the mast.

b. Use one of the inserts 2-4 to fit the front screw for the rear foot loop to your foil. Make sure the screw

is long enough to go through both the tab on the foot strap and the board, so it can be screwed into the

hydrofoil.

7. Remove the covers from the glider and mast before using the hydrofoil on the water.

3.3.

DISMANTLING THE HYDROFOIL

To dismantle the Daytona DOS hydrofoil, follow the instructions above in reverse order.

Brass Inserts for

Board connection

ASSEMBLING & DISMANTLING THE HYDROFOIL

DUOTONE DAYTONA DOS 21 MANUAL

1 1