DUOVAC A10-260I-CN Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DUOVAC A10-260I-CN. DUOVAC A10-260I-CN 10 pagina's.
Pagina afdrukken
3. MODELS
Internal control
module
Machine washable
permanent fi lter
Aluminum canister
NOTE
APPLICABLE TO ALL POWER UNITS: in order to avoid overheating, we
»
recommend 12in / 30cm clearance all around the power unit�
4. INSTALLATION
POWER UNIT
Fig. 1
Mounting bracket is the same for all units
5 | DOC-568_EN REV04
Air intake
Air outlet
Disposable fi ltration
bag (optional)
Internal control
module
Machine washable
permanent fi lter
Aluminum canister
The power unit must be installed in a ventilated area, easily accessible and away from any heat
source. It should also be close to an accessible electrical outlet.
Determine the location of the power unit on the wall; we recommend that the power unit
1�
be fastened at 60" / 1,5m from the ground in order for the dust canister to be readily
accessible; allow 12" / 30cm clearance on all sides of the power unit. When possible, it is
advisable to install the power unit on a concrete wall in order to minimize the vibrations;
Gypsum wall:
2�
• Prepare the wall by installing a plywood mounting board (not provided) 16" / 40cm high
by 3/4" / 2cm thick and wide enough to be screwed to at least 2 studs;
• Fasten the mounting bracket to the mounting board with the provided screws;
Concrete wall:
3�
• Drill the holes with a concrete drill bit;
• Insert the provided wall anchors into the drilled holes;
• install the mounting bracket with the provided screws into the anchors;
NOTE
You can still install a plywood mounting (16" / 40cm x 10" / 25cm x
»
3/4" / 2cm) board if desired;
You can use provided screws to fi x mounting board on the wall, but
»
cannot use them for installing the mounting bracket on the mounting
board because of their length� You need to use shorter screws (not
provided)�
IMPORTANT
Always use the right type of screws for the surface you are working with (wood,
concrete, metal...)
Insert the power unit bracket into the mounting bracket (Fig. 1).
4�
Insert the PVC pipe into the air intake coupling; DO NOT GLUE!
5�
ORIGINAL INSTRUCTIONS
Air intake
Air outlet
Disposable fi ltration
bag (optional)