AEV ACUO 908 Serie Beknopte handleiding - Pagina 11

Blader online of download pdf Beknopte handleiding voor {categorie_naam} AEV ACUO 908 Serie. AEV ACUO 908 Serie 17 pagina's. On air broadcast console

Pagina afdrukken
AEV ACUO 908 Serie Beknopte handleiding
Room & Studio section
1
2
3
4
5
Control Studio selection
1 – Button for selecting the EXT input for
routing it to the Control Studio output.
2 - Button for selecting the master PGM output
for routing it to the Control Studio output.
3 - Button for selecting the master UTL output
for routing it to the Control Studio output.
4 - Button for selecting the master AUX output
for routing it to the Control Studio output.
5 - Button for selecting the CUE bus for routing
it to the Control Studio output.
Control Room selection
6 – Button for selecting the EXT input for
routing it to the Control Room outputs.
7 - Button for selecting the master PGM output
for routing it to the Control Room outputs.
8 - Button for selecting the master UTL output
for routing it to the Control Room outputs.
9 - Button for selecting the master AUX output
for routing it to the Control Room outputs.
Master setup
Master knob jog ; directly it select the Gain headphone level, the range is -∞ ÷ +8 dB;
in sequence, the following commands:
1th push-buttom Control Room level (-∞ ÷ +8 dB)
2th push-buttom Control Studio level (-∞ ÷ +8 dB)
3th push-buttom PGM output level (-12 ÷ +12 dB)
4th push-buttom External input level (-12 ÷ +12 dB)
5th push-buttom CUE interlock (OFF/ON)
6th push-buttom PGM Digital sample rate ( 32, 44.1, 48, 96 KHz )
7th push-buttom UTL Digital sample rate ( 32, 44.1, 48, 96 KHz )
8th channel selection to associate the command I / O Start/Stop A (GPIO 1)
9th channel selection to associate the command I / O Start/Stop B (GPIO 2)
10th channel selection to associate the command Out Start/Stop C
AEV Broadcast Srl, via della Tecnica 33 – 40050 Argelato (BO) Italy
ACUO 908 Serie - AEV ON AIR CONSOLE
6
7
8
9
10
Web site www.aev.eu
11
Talk Back
10 - Button to active the Talkback function to the
Control Studio outputs.
Talk back Regia to Studio:
When the TB (talk back) button is pressed, the
signal of the enabled microphone is sent to the
Control Studio output.
•
Channel with function talkback to studio
(TBST: ON)
•
Channel in STOP
What happens:
•
the Talk back button of the remote fader
up
•
the previous selection of the Control Studio flashes
•
the audio signal present in the Control studio is
replaced by the channel selected in TB
Talk back Studio to Regia :
(need the Remote Fader)
•
Channel
connected to the Remote Fader unit
talkback function activated (STCR: ON)
•
Channel in STOP
What happens when the remote TB (talk back)
button is pressed:
•
the Talk back button of ACUO
•
the previous selection of the Control Room flashes
•
the audio signal present in the Control Room is
replaced by the channel connected to the Remote
Fader unit
•
the signal of the enabled microphone is sent
to the Control Room output.
lights
with
flashes