Conquip Powerbrush Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Conquip Powerbrush. Conquip Powerbrush 14 pagina's.
Ook voor Conquip Powerbrush: Gebruiksaanwijzing (15 pagina's)
Pagina afdrukken
Original Working Instructions
Usage Instructions
Using the Powerbrush
1. Open the water tap, to allow water to dribble evenly from the dispenser bar
at the front of the Powerbrush.
2. For the pressurised water spray model, turn the electric swtich on.
3. Lower the brush to the floor.
4. Ensure that the floating forks are centralised and the forks are level.
5. Activate the brush by operating the hydraulic circuit of the forklift or
telehandler.
6. Drive forward at a suitable speed to achieve the desired sweep results.
7. Once the hopper is full, lift the Powerbrush to a suitable location and reverse
the flow of the hydraulic circuit to empty the hopper.
Removing the Powerbrush from your Machine
1. To remove the Powerbrush from a forklift or telehandler, first park in a
suitable place away from site traffic but somewhere that is easily accessible
when the unit is required again.
2. Apply the park brake and switch of the forklift engine.
3. Operate the auxiliary control lever, without the engine running, to release the
pressure and close the hopper.
Closing the hopper will prevent a build up in the hydraulic hoses.
4. Exit the machine cab to follow the next steps.
5. Turn the water tap to the 'off position'. If using the pressurised water spray,
make sure the power supply switch is turned off so that the orange beacon is
no longer flashing.
In freezing conditions, remove the water hose and drain the tank.
6. Remove the hydraulic hoses from the 2 outputs on the arm of the machine.
CAUTION: Use gloves as the connections will be hot due to hydraulic oil
passing through the hoses.
7. Remove the fork retaining pins and refit them into their storage holes.
8. Return to the machine's cab to detach the Powerbrush from the forklift or
telehandler.
User Guide - Powerbrush
Scan for video guide!
9. Slowly reverse the forklift or telehandler to remove the forks from the fork
pockets.
10. Conquip advise lubricating the grease points after use, as demonstrated in
our 'How to use the Powerbrush' video. Scan the QR code at the top of this
User Guide to watch.
11. Recharge the battery.
19