Brainworx bx_control Handleiding Handboek - Pagina 9

Blader online of download pdf Handleiding Handboek voor {categorie_naam} Brainworx bx_control. Brainworx bx_control 17 pagina's. Control listening and monitoring instrument. m/s matrix with mono maker and stereo width control. for scope systems

Pagina afdrukken

TIPPS for STEREO WIDTH CONTROL & MONO MAKER use:

TRY increasing the STEREO WIDTH (see 6!) of a stereo

signal (such as a guitar or keyboard sub-group or FX return!)

until your CORRELATION METER (see 7!) indicates phase

problems (goes into the RED...). NOW: turn the MONO MAKER

up to about 300 or 500 Hz (even higher if needed, this will

depend on the actual signal being "played") and watch the

CORRELATION METER go back to GREEN, indicating that your

phases are ok again!

This way it is actually possible to SPREAD stereo images

much further than with any other stereo expansion tool (that

we knew of before inventing the MONO MAKER ☺) – but

WITHOUT running into the phase problems usually arising out

of more or less "heavy" stereo image manipualations, or at

least much less...

the bx_control is the PERFECT WEAPON to be inserted into

ANY stereo sub-group of a mix session and will drastically

improve your possiblilities to increase your stereo width of any

stereo signal.

7. CORRELATION METER LEDs

a standard CORRELATION METER tool to monitor the phases (and

potential phase problems!) of your stereo mix / signal.

- 1 means your mix / signal is OUT OF PHASE (180°).

+1 means your mix / signal is IN PHASE (0°).

"0" (zero) means that there is either:

no signal present

signal on only ONE channel

phases of L&R channels are shifted exactly 90°.

CORRELATIONS METERS oscillate between 0 and +1 while SHORT

flashes of the RED LEDs (negative values) can usually be ignored.

PERMANENT RED LEDs will indicate heavy phase problems in

the mix / signal and should be taken serious.

Try the MONO MAKER to cure any phase problems you might

find listening to your mix or monitoring the CORRELATION METER

LEDs. The higher you set the MONO MAKER FREQUENCY the

more mono your mix will be, and the less phase problems should

occur in your stereo mix / signal.

regular

(and

proper)

stereo

mix

will

make

the