aevit 2.0 Installatiehandleiding - Pagina 11

Blader online of download pdf Installatiehandleiding voor {categorie_naam} aevit 2.0. aevit 2.0 17 pagina's. Mounting brackets

prIMArY INpUT

2.5 OThEr MOUNTINg OpTIONS

(CONTINUEd)

CUTTINg ThE qUICk AdjUST UppEr pOLE

If only one input device is being mounted to the quick

Adjust Upper Pole, the extra length of the bracket can

be removed. EMC recommends that the cut be made

3" from the "pole side" of the quick adjust upper pole as

shown in Figure 20.

Figure 21 shows an application where cutting the

quick Adjust Upper Pole was necessary in order for the

mounting bracket to fit the door panel.

DEBUR ALL EDGES AFTER CUTTING ThE qUICK

ADjUST UPPER POLE.

WARNING:

FAILURE TO TIGhTEN ALL ADjUSTMENT KNOBS

COMPLETELy COULD CAUSE AN ACCIDENT RE-

SULTING IN SERIOUS INjURy AND / OR DEATh.

ATTAChINg ONLY ThE INpUT dEVICE SwIVEL BrACkET

There are a few applications where the entire Input Device

Articulating Swivel Bracket is not needed and only the Input

Device Swivel Bracket is used (Figure 22). If this is the case,

the installer will have to provide the following hardware:

(1) 3/8" x 2 1/2" Grade 8 hex head Bolt

(2) 3/8" Flat Washers

(1) 3/8" Lock Nuts

Some of the hardware from the Input Device Articulating

Swivel Bracket will be used as well. EMC recommends that

the installer review page 2-5 to familiarize themselves with

the components that make up the Input Device Articulating

Swivel Bracket assembly.

NOTE:

(BrkT-AEVIT-FLr & BrkT-AEVIT dOOr)

cuT hERE

QuIck ADjusT

uPPER POlE

AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL

FIGuRE 20

FIGuRE 21

INPuT DEvIcE

SwIvEL BRACkET

ONLY

FIGuRE 22

2-8